Processing and properties of thin film pyroelectric devices
نویسندگان
چکیده
Pyroelectric PbTiO3 thin films devices with two temperature compensating elements on a SiO2/Si3N4 membranes have been fabricated and characterized. The measured voltage responsivity as a function of radiation modulation frequency has been compared to finite element model calculation. The relevant film properties have been compared for sputter and a sol-gel deposition techniques. The calculated responsivity amounts to 30 V/W. The measured pyroelectric signal is a few μV.
منابع مشابه
Pyroelectric properties of finite size ferroelectric thin films with structural transition zones
A Fermi-type Green’s function is used to study pyroelectric properties of the thin filmwith finite sizes in three dimensions based on a modified transverse Ising model. The results demonstrate that a decrease in the lateral size of the film has a disadvantageous influence on the pyroelectric coefficient of the thin film. & 2009 Elsevier B.V. All rights reserved.
متن کاملThin-film Encapsulation of Organic Light-Emitting Diodes Using Single and Multilayer Structures of MgF2, YF3 and ZnS
In this research, the lifetime of green organic light emitting diodes (OLEDs) is studied using four passivation layers. To encapsulate the OLEDs, MgF2, YF3, composed of alternating MgF2/ZnS and YF3/ZnS layers were grown by thermal vacuum deposition. Measurements show that the device lifetime is significantly improved by using YF3 and ZnS as passivation layers. However, diodes encapsulated by Mg...
متن کاملPYROELECTRIC PROPERTIES OF La-Sr-Co-O/Pb-La-Ti-O/La-Sr-Co-O HETEROSTRUCTURES
The realization of a commercially viable, thin-film uncooled pyroelectric detector has been the focus of research for several years. As part of this effort, we show that a conventional metallic electrode system (typically Pt) can be replaced with a conductive oxide such as LaxSr(1–x)CoO3 (LSCO). In addition to being crystallographically compatible with the lead-based, pyroelectric oxides such a...
متن کاملThe Characterization and Fabrication of Pyroelectric Infrared Sensor and Application of Thermal Image Array
The pyroelectric infrared (PIR) sensor with the lead-titanate (PbTiO3) thin film has been successfully fabricated. A RF planar magnetron sputter was used to deposit PbTiO3 thin film. A perovskite thin film can be obtained. From the properties measurement we can obtain the remanent polarization Pr = 20.8 μc/cm and coercive electric field Ec = 79.365 kV/cm. The pyroelectric coefficient of 1.09 × ...
متن کاملUncooled Thin Film Infrared Imaging Device with Aerogel Thermal & dGqgD $ J ? - Deposition and Planarization Techniques 0971
:mCl Quum INSrnCrnD3 Abstract We have successfully integrated a thermally insulating silica aerogel thin film into a new uncooled monolithic thin film infrared (E) imaging device. Compared to other technologies (bulk ceramic and microbridge), use of an aerogel layer provides superior thermal isolation of the pyroelectric imaging element from the relatively massive heat sinking integrated circui...
متن کامل