The Catalytic Hydrogenation 2,4_dinitrotoluene in a Continuous
نویسنده
چکیده
Abstrati-An experimental study of the catalytic hydrogenation of 2,4_dinitrotoluene (DNT) in a miniinstallation with a continuously operated stirred three-phase slurry reactor and an evaporating solvent is discussed_ Some characteristic properties of the reactor system and the influence of the operating parameters on the performance of the reactor are illustrated. The experimental results are compared with the predictions based on a mathematical model of the reactor system. The results indicate that the assumption of complete saturation with solvent vapors of the gas exit stream out of the reactor does not hold for our small laboratory reactor. It is concluded that, for the mini-installation, the model describes well the operation and further the behavior of the reactor system, and that the model should be fully adequate for large industrial reactors. Further, it was -concluded that the kinetics cannot be based on the overall hydrogen conversion determinations alone, and reevaluation of chemisorption constants by analysis of the reactor product composition also is required as soon as a new batch of catalyst is taken into use.
منابع مشابه
Nickel Hydrogenation Composite Catalysts Modified by Zirconium in Competitive Benzene Hydrogenation: Effect of Modifiers
A co-impregnation method was applied to the Ni/Zr-HMS/HZSM-5 catalyst (with various amounts of zirconium) during the hydrogenation of benzene. The physicochemical properties of the prepared nickel catalyst were characterized using X - ray diffraction, X - ray fluorescence, Fourier transform infrared spectroscopy, ultraviolet-visible diffuse reflectance spectroscopy, temperature-programmed desor...
متن کاملEffects of solvents polarity parameters on heterogeneous catalytic hydrogenation of cyclohexene in molecular solvents
Heterogeneous catalytic hydrogenation of cyclohexene, catalyzed by Pt/A1203, was carried out in thirteenvarious solvents (four alcoholic solvents, six aprotic polar solvents and three non polar solvents) at 25 °C.Single-parameter correlations of logk vs. normalized polarity parameter (ETN), hydrogen-bond acceptorbasicity (p), hydrogen-bond donor acidity (a) and dipolarity/polarizibility (it*) d...
متن کاملApplication of Response Surface Methodology for Catalytic Hydrogenation of Nitrobenzene to Aniline Using Ruthenium Supported Fullerene Nanocatalyst
In this study fullerene functionalized using oleum (H2SO4·SO3), followed by the hydrolysis of the intermediate cyclosulfated fullerene as well as an oxidizing agent was employed to functionalize the fullerenes. Ruthenium was then added by the impregnation method or deposited on the functionalized fullerene. Subsequent to this step, Response Surface Methodol...
متن کاملCatalytic Investigation of Aluminum Effects on Benzene Hydrogenation Selectivity over Nickel Supported HMS/HZSM-5 Composites
Ni/Al-HMS/HZSM-5 catalysts with varying amounts of Si/Al ratios were prepared via the impregnation method and evaluated for the hydrogenation of benzene at 130−190 °C. To study the catalyst characterization, various methods were used as X-ray diffraction, X-ray fluorescence, Fourier transform infrared spectroscopy, ultraviolet-visible diffuse reflectance spectroscopy, temperature-programmed des...
متن کاملCatalytic nanoreactors in continuous flow: hydrogenation inside single-walled carbon nanotubes using supercritical CO2.
One nanometre wide carbon nanoreactors are utilised as the reaction vessel for catalytic chemical reactions on a preparative scale. Sub-nanometre ruthenium catalytic particles which are encapsulated solely within single-walled carbon nanotubes offering a unique reaction environment are shown to be active when embedded in a supercritical CO2 continuous flow reactor. A range of hydrogenation reac...
متن کامل