Gear Noise and Vibration – a Literature Survey
نویسنده
چکیده
This paper is a survey of the literature on gear noise and vibration. It is divided into three parts, “Transmission error”, “Dynamic models” and “Noise and vibration measurement”. Transmission error (TE) is considered to be an important excitation mechanism for gear noise and vibration. The definition of transmission error is “The difference between the actual position of the output gear and the position it would occupy if the gear drive were perfectly conjugate”. Dynamic models of the system consisting of gears, shafts, bearings and gearbox casing are useful in order to understand and predict the dynamical behaviour of a gearbox. Noise and vibration measurement and signal analysis are important tools when experimentally investigating gear noise because gears create noise at specific frequencies, related to number of teeth and the rotational speed of the gear.
منابع مشابه
Simulation and Experimental Study of Vibration and Noise of Pure Electric Bus Transmission based on Finite Element and Boundary Element Methods
Since the electric motor of pure electric vehicle replaced the engine, the "masking effect" disappears, and the problem of vibration and noise of the transmission becomes prominent. This is generated during the gear meshing and is transmitted to the housing through the shaft and bearing. Thereby, radiation noise of the housing are generated. The prediction and analysis...
متن کاملMotor Gear Fault Diagnosis by Current, Noise and Vibration on AC Machine Considering Environment
Lots of motors have been being used in industry. Therefore many researchers have studied about the failure diagnosis of motors. In this paper, the effect of measuring environment for diagnosis of gear fault connected to a motor shaft is studied. The fault diagnosis is executed through the comparison of normal gear and abnormal gear. The measured FFT data are compared with the normal data and an...
متن کاملResults from a New Separation Algorithm for Planetary Gear System Vibration Measurements
Results are presented from a new algorithm developed for separating the vibration signals from a planetary gear system into separate signals attributable to each planet gear. From the separate signals, time synchronous average signals are produced for each planet gear and for the sun gear meshing with each planet gear. Assessments of the individual planet and sun gears can be made from these ne...
متن کاملGear Geometry for Reduced and Robust Transmission Error and Gearbox Noise
Gear geometry was optimized for decreased transmission error in order to reduce gearbox noise. Robustness with respect to gear deviations and varying torque was considered in order to find a gear geometry giving low noise in the appropriate torque interval despite deviations from the nominal geometry due to manufacturing tolerances. Static and dynamic transmission error as well as noise and hou...
متن کاملMathematical Model and Vibration Analysis of Aircraft with Active Landing Gear System using Linear Quadratic Regulator Technique
This paper deals with the study and comparison of passive and active landing gear system of the aircraft and dynamic responses due to runway irregularities while the aircraft is taxying. The dynamic load and vibration caused by the unevenness of runway will result in airframe fatigue, discomfort of passengers and the reduction of the pilot’s ability to control the aircraft. One of the objectiv...
متن کامل