Prst - Ab 4 Photonic Band Gap Fiber
نویسنده
چکیده
There are three requirements in making a traveling wave accelerator: longitudinal electric field, synchronization, and confinement. We present and analyze a conceptually new kind of charged particle accelerator, making use of a photonic band gap lattice for field confinement near the beam axis, and employing dielectric material to produce a speed of light synchronous longitudinal electric field. An example structure design is presented. We also discuss nonlinear effect and other configurations without higher order dipole modes. Parallel scheme and fabrication are presented.
منابع مشابه
Investigating the Properties of an Optical Waveguide Based on Photonic Crystal with Point Defect and Lattice Constant Perturbation
In this paper, a photonic crystal waveguide with point defects and lattice constant perturbations of +5%, -5% are being investigated. Firstly waveguide structures with constant and specific parameters are being studied and photonic band gap diagrams for TE/TM modes are depicted; then pulse propagation in the frequencies available in the band gap are shown. After that, effects of parameters like...
متن کاملMode Multiplexing at 2×20Gbps over 19-cell Hollow-Core Photonic Band Gap Fibre
This paper demonstrates the first mode-multiplexed system over 19-cell hollow-core photonic band gap fibre, at 2×20Gbps using the LP0,1 and LP2,1-like modes. OCIS codes: 060.0060 (Fiber optics and optical communications), 060.5295 (Photonic crystal fibers)
متن کاملGas Sensor Based on Large Hollow-Core Photonic Bandgap Fiber
One concern in using photonic band-gap fiber (PBGF) as a gas sensor is the response time. In this type of the gas sensors, response time is the time required for gas to diffuse into the hollow-core. So considering a large hollow-core PBGF (HC-PBGF), the response time can be significantly reduced. But in the large HC-PBGF, the fundamental issue is the presence of higher order modes (HOMs). Somet...
متن کاملSingle-Mode Photonic Band Gap Guidance of Light in Air.
The confinement of light within a hollow core (a large air hole) in a silica-air photonic crystal fiber is demonstrated. Only certain wavelength bands are confined and guided down the fiber, each band corresponding to the presence of a full two-dimensional band gap in the photonic crystal cladding. Single-mode vacuum waveguides have a multitude of potential applications from ultrahigh-power tra...
متن کاملTwo-Mode Multiplexing at 2×10.7 Gbps over 7-Cell Hollow- Core Photonic Band Gap Fiber
We demonstrate two-mode multiplexing at 2×10.7 Gbps over 7-cell hollow-core photonic band gap fiber. BER performances below FEC threshold limit (3.3×10 -3 ) are shown for both data channels. OCIS codes: (060.2270) Fiber characterization; (060.2330) Fiber optics communications
متن کامل