A Power Electronic Fault Diagnosis Method Based on Bond Graph Model
نویسندگان
چکیده
Propose a fault diagnosis method which combines analytical redundancy with bond graph model for electrolytic high power rectifier system. Firstly, using the software 20-sim, the author builds a bond graph model of the system and established a diagnostic bond graph model through adding virtual sensor in bond graph model; then, according to the causal relationship in the components, analytical redundancy relationship and its fault characteristic matrix are set up; finally, comparing the observed characteristics matrix and fault characteristic matrix, fault can be detected and isolated quickly. The simulation results demonstrate that the method is convenient and effective for Power electronic fault diagnosis. Copyright © 2014 IFSA Publishing, S. L.
منابع مشابه
Directed factor graph based fault diagnosis model construction for mode switching satellite power system
Satellite power system is a complex, highly interconnected hybrid system that exhibit nonlinear and mode switching behaviors. Directed factor graph is an inference model for fault diagnosis using probabilistic reasoning techniques. A novel approach for constructing the directed factor graph structure based on hybrid bond graph model is proposed. The system components status and their fault symp...
متن کاملVariable Speed Wind Turbine DFIG Back to Back Converters Open-Circuit Fault Diagnosis by Using of Combiniation Signal-Based and Model-Based Methodes
Condition monitoring (CM) and Fault Detection (FD) of wind turbine lead to increase in reliability and availability of turbine. IGBT open circuit of wind turbine converter will bring about depletion in output current of converter and as a result, reduction in production of wind turbine power. In this research, back to back converter IGBT open - gate fault for wind turbine based on DFIG is detec...
متن کاملStator Turn-to-Turn Fault Detection of Induction Motor by Non-Invasive Method Using Generalized Regression Neural Network
Condition monitoring and protection methods based on the analysis of the machine's current are widely used according to non-invasive characteristics of current transformers. It should be noted that, these sensors are installed by default in the machine control center. On the other hand, condition monitoring based on mathematical methods has been proposed in literature. However, they are model b...
متن کاملOn the development of a sliding mode observer-based fault diagnosis scheme for a wind turbine benchmark model
This paper addresses the design of an observer-based fault diagnosis scheme, which is applied to some of the sensors and actuators of a wind turbine benchmark model. The methodology is based on a modified sliding mode observer (SMO) that allows accurate reconstruction of multiple sensor or actuator faults occurring simultaneously. The faults are reconstructed using the equivalent output err...
متن کاملOn the development of a sliding mode observer-based fault diagnosis scheme for a wind turbine benchmark model
This paper addresses the design of an observer-based fault diagnosis scheme, which is applied to some of the sensors and actuators of a wind turbine benchmark model. The methodology is based on a modified sliding mode observer (SMO) that allows accurate reconstruction of multiple sensor or actuator faults occurring simultaneously. The faults are reconstructed using the equivalent output err...
متن کامل