FMCW MMW Radar for Automotive Longitudinal Control
نویسنده
چکیده
The contents of this report reflect the views of the authors who are responsible for the facts and the accuracy of the data presented herein. The contents do not necessarily reflect the official views or policies of the State of California. This report does not constitute a standard, specification, or regulation. CALIFORNIA PATH PROGRAM INSTITUTE OF TRANSPORTATION STUDIES UNIVERSITY OF CALIFORNIA, BERKELEY
منابع مشابه
Broadband Millimeter-wave FMCW Radar for Imaging of Humans
We present design and realization of a broadband FMCW Radar working in the Millimeter-Wave (MMW) region. The usable frequency range lies between 91GHz and 102GHz. We use a homodyne radar setup. Thus only one MMW source is necessary which is used for TX and LO generation simultaneously. The complex RX radar signal is calculated by a Hilbert transform in order to avoid a broadband MMW IQ mixer. A...
متن کاملDesign of FMCW Radars for Active Safety Applications
With 28.000 road fatalities in 2012 in Europe, car manufacturers, automotive electronics suppliers, and universities are working to develop new electronic systems for accident prevention and collision mitigation. In the near future, vehicle-tovehicle and vehicle-to-infrastructure networks based on dedicated short-range communication (DSRC) technology will warn drivers when dangerous conditions ...
متن کاملHigh-Resolution Angle Estimation for an Automotive FMCW Radar Sensor
This paper introduces the application of high-resolution angle estimation algorithms for a 77GHz automotive long range radar sensor. Highresolution direction of arrival (DOA) estimation is important for future safety systems. Using FMCW principle, major challenges discussed in this paper are small number of snapshots, correlation of the signals, and antenna mismatches. Simulation results allow ...
متن کاملDesign of an FMCW radar baseband signal processing system for automotive application
For a typical FMCW automotive radar system, a new design of baseband signal processing architecture and algorithms is proposed to overcome the ghost targets and overlapping problems in the multi-target detection scenario. To satisfy the short measurement time constraint without increasing the RF front-end loading, a three-segment waveform with different slopes is utilized. By introducing a new ...
متن کاملSignal Processing for Closing Vehicle Detection
The performance of automotive controller area network (CAN) for safety driving applications based on the radar sensors is tightly related to the target vehicle detection. The presented paper deals with introduction of appropriate signal detection and signal processing techniques for closing vehicle detection (CVD) based on FMCW radar.
متن کامل