Novel method for evaluation of hindfoot alignment in weight-bearing position using laser beam

نویسندگان

  • Tadasuke Ohnishi
  • Mitsumasa Hida
  • Yukio Nakamura
  • Chikamune Wada
چکیده

[Purpose] It is clinically important to accurately evaluate the alignment of hindfoot alignment from the body surface in weight-bearing position. In general, measurement is carried out using a goniometer, but the measurement with goniometer requires experience, and the reliability in this measurement is also in question. Therefore, it is necessary to establish a clinical measurement method to replace the goniometer. As a solution, we devised a hindfoot alignment measurement method with laser beam (HAML), which measures hindfoot alignment along the body surface using a laser beam. This study aimed to study the correlation between the measurement result along the body surface with laser or goniometer and that of radiography with regard to hindfoot alignment. [Subjects and Methods] Subjects included 23 individuals with knee osteoarthritis. Their hindfoot alignment using radiography and goniometry were measured. The correlation between the measurement result along the body surface with or without laser and radiography was investigated. [Results] The correlation between HAML and radiography was better than that between HAML and goniometry. [Conclusion] The correlation between radiography and HAML for measuring hindfoot alignment was good. This finding implies that HAML can be used as a screening test or epidemiological survey in regional medicine.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

The Effect of Total Knee Arthroplasty on Hindfoot Alignment in Patients with Severe Genu Varum and Genu Valgum

Background: The maintenance of deformity in the ankle and hindfoot after correction of knee deformity following kneearthroplasty may cause abnormal tension in the knee and patient dissatisfaction. The aim of this study was to determinethe effect of knee arthroplasty on the hindfoot alignment in patients with severe genu varum and valgum.Methods: A total of 84 patients with pri...

متن کامل

Comparison of Double and Single Leg Weight-Bearing Radiography in Determining Knee Alignment

  Background: Knee malalignment is an important modifiable cause of osteoarthritis (OA). Surgical therapeutic procedures depend on proper knee alignment assessment. The purpose of this study was to compare knee alignment parameters between double and single leg weight-bearing radiographs and to evaluate the reproducibility of inter- and intra-observer measurements. Methods: One hundred eight p...

متن کامل

A computer assessment of the effect of hindfoot alignment on mechanical axis deviation

Lower limb malalignment is a common cause of disability that increases risk of osteoarthritis (OA). Treatment of OA may require an osteotomy or arthroplasty, which mandate accurate evaluation of mechanical loading on the limbs to achieve optimal alignment and minimal implant wear. Surgical planning uses a conventional method of mechanical axis deviation (MADC) measured from the center of the fe...

متن کامل

A novel method for laser forming of two-step bending of a dome shaped part

In recent decades, one of the challenges in sheet metal forming was production of two-step bending surfaces without mechanical tools and external force or by a combination of heat source and mechanical tools. Forming with a heat source such as laser beam has the potential for forming arbitrary 3D shapes such as two-step bending surfaces. In this paper a novel method for laser forming of complic...

متن کامل

Numerical simulation of laser beam welding of Ti6Al4V sheet

This paper was aimed to report the 3D finite element analysis simulation of laser welding process of Ti6Al4V 1.7 mm sheets in butt joint in order to predict the temperature distribution, hardness, and weld geometry. The butt-joint welds were made using CO2 laser with the maximum power of 2.2 kW in the continuous wave mode. A part of the experimental work was carried out to verify the weld geome...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره 30  شماره 

صفحات  -

تاریخ انتشار 2018