Enrichment of Secondary Wastewater Sludge for Production of Hydrogen from Crude Glycerol and Comparative Evaluation of Mono-, Co- and Mixed-Culture Systems
نویسندگان
چکیده
Anaerobic digestion using mixed-culture with broader choice of pretreatments for hydrogen (H₂) production was investigated. Pretreatment of wastewater sludge by five methods, such as heat, acid, base, microwave and chloroform was conducted using crude glycerol (CG) as substrate. Results for heat treatment (100 °C for 15 min) showed the highest H₂ production across the pretreatment methods with 15.18 ± 0.26 mmol/L of medium at 30 °C in absence of complex media and nutrient solution. The heat-pretreated inoculum eliminated H₂ consuming bacteria and produced twice as much as H₂ as compared to other pretreatment methods. The fermentation conditions, such as CG concentration (1.23 to 24 g/L), percentage of inoculum size (InS) (1.23% to 24% v/v) along with initial pH (2.98 to 8.02) was tested using central composite design (CCD) with H₂ production as response parameter. The maximum H₂ production of 29.43 ± 0.71 mmol/L obtained at optimum conditions of 20 g/L CG, 20% InS and pH 7. Symbiotic correlation of pH over CG and InS had a significant (p-value: 0.0011) contribution to H₂ production. The mixed-culture possessed better natural acclimatization activity for degrading CG, at substrate inhibition concentration and provided efficient inoculum conditions in comparison to mono- and co-culture systems. The heat pretreatment step used across mixed-culture system is simple, cheap and industrially applicable in comparison to mono-/co-culture systems for H₂ production.
منابع مشابه
Influence of Different Culture Selection Methods on Polyhydroxyalkanoate Production at Short-term Biomass Enrichment
In this study, the potential of four different culture selection methods under short-term enrichment time (STE) to accumulate PHA-producing bacteria in mixed activated sludge was compared and the most efficient culture selection method was introduced. This means, PHA-producing microbial community was firstly enriched in a sequencing batch bioreactor (SBR) with four different selection methods i...
متن کاملEffects of nanobubble aeration in oxygen transfer efficiency and sludge production in wastewater biological treatment
Low efficiency of conventional aeration techniques and the excessive production and disposal of sludge are great concerns in biological wastewater treatment systems. The present study aimed to evaluate the active sludge method using batch reactors under continuous operation to determine the efficiency of aeration and sludge production through microbubble and nanobubble aeration. The results ind...
متن کاملSlovak Society of Chemical Engineering Institute of Chemical and Environmental Engineering Slovak University of Technology in Bratislava PROCEEDINGS
Work was focused on possibilities of biogas production from a crude glycerol. This material is by-product of biodiesel production. In the work results of crude glycerol treatment in the laboratory mixed reactor and in the laboratory UASB reactors are described. Results from long-term co-digestion of maize silage and crude glycerol in full scale anaerobic reactor at biogas plant are also discuss...
متن کاملEvaluation of Biomass Production and Wastewater Nutrient Removal Using Microalgae: Sustainable Strategy to CO2 Bio-Fixation and Bioenergy Production Approach
Nowadays, the replacement of renewable energies such as biofuels is one of the main priorities in environmental programming and investments. This study is based on sustainable strategy towards integrating algal biomass generation as a green feedstock with wastewater treatment, CO2 bio-fixation, and bioenergy production. Therefore, the performance of Trichormus variabilis in ...
متن کاملComparative investigation on the correction factors of hydrogen permeability on CNTs-Mixed matrix membrane
This paper discusses different important gas permeation models such as “Maxwell”, “Bruggeman”, “Lewis-Neilson”, and “Pal” models to predict “Mixed Matrix Membranes” (MMMs) performance. The main parameter considered and discussed is the permeability of Hydrogen on Carbon Nanotubes (CNTs)-MMM. For evaluation of the theoretical models, experimental data of permeability for H2 were compa...
متن کامل