A Coherent FM Laser Radar Based System for Remote Metrology in ITER*

The plasma facing surfaces in ITER must be aligned to millimeter accuracy with respect to the magnetic flux surfaces to prevent impurity influx into the plasma and to avoid component damage. Checking of in-vessel component alignment during initial assembly, operation, and subsequent maintenance is anticipated. A fully remote metrology system is necessary, particularly since major remote operations such as shield blanket exchange and divertor cassette replacement are planned. The metrology system must be compatible with the ITER in-vessel environment of high gamma radiation (-IO6 Whr), super-clean ultra-high-vacuum Torr), and elevated temperature (-200°C). A fast scanning rate is required since the plasma facing surface in ITER is very large (-1500 m2). A coherent FM laser radar based metrology system, developed by Coleman Research Corporation, is being adopted to accomplish this task. Conceptually, this metrology system consists of a compact (few cm3) remotely deployed laser transceiver optics module, linked through fiber optics to the laser source and imaging units that are located outside the biological shield. Range measurements conducted on a variety of surfaces using the system have yielded sub-millimeter accuracy. Therefore, the technique will easily meet the precision requirement for the ITER application. Computer simulations have been carried out to determine the optimum number of units required for complete mapping of the plasma facing surfaces. Most in-vessel components of the system appear to be radiation hardenable and vacuum compatible. Details of the system and developments required to make it fully compatible for ITER metrology application will be elaborated. and operation are anticipated. A controlled 3D metrology system, that can be remotely deployed to perform accurate mapping of the ITER in-vessel components and their support structures (i.e., vacuum vessel, blanketlshield, divertor, etc.) is required. Inspectionhiewing of plasma facing surfaces is also anticipated for troubleshooting during plasma operation.