Low Noise Amplifier Application Using Negative Feedback for Ultra-wideband Applications
نویسندگان
چکیده
This paper presents a design of Ultra Wideband Low Noise Amplifier (LNA) with Negative Feedback and multisection matching network implementing on Microstrip design technique. The design started with selecting a transistor which is Super-low noise InGaAs HEMT MGF4937AM transistor that support ultra-wideband frequencies. In order to achieve ultra-wideband LNA, two different techniques which implementing negative feedback and multisection matching. The uses of negative feedback would degrade the gain while increasing the stability of the system. However, this problem can be overcome by introducing cascaded topology which can increase the gain while leaving the system stable. This LNA design is based on Rogers 4350B microstrip characteristic designed using Advanced Design System (ADS) software. The LNA provides an input return loss (S11) which less than -10 dB and the gain (S21) more than 15 dB and noise figure less than 4dB. UWB LNA can be used on several types of application such as wireless sensor and personal area networks, ground penetrating radars, and medical applications.
منابع مشابه
A High Gain and Forward Body Biastwo-stage Ultra-wideband Low Noise Amplifier with Inductive Feedback in 180 nm CMOS Process
This paper presents a two-stage low-noise ultra-wideband amplifier to obtain high and smooth gain in 180nm CMOS Technology. The proposed structure has two common source stages with inductive feedback. First stage is designed about 3GHz frequency and second stage is designed about 8GHz. In simulation, symmetric inductors of TSMC 0.18um CMOS technology in ADS software is used.Simulations results ...
متن کاملA New Ultra-Wideband Low Noise Amplifier With Continuous Gain Control
This paper presents a new variable gain low noise amplifier (VG-LNA) for ultra-wideband (UWB) applications. The proposed VG-LNA uses a common-source (CS) with a shunt-shunt active feedback as an input stage to realize input matching and partial noise cancelling. An output stage consists of a gain-boosted CS cascode and a gain control circuit that moves the high resonant frequency to higher freq...
متن کاملA Low Power UWB-LNA using Active Dual Loop Negative Feedback in CMOS 0.13µm
A low noise amplifier for UWB and broadband applications is presented. The active dual loop negative feedback architecture dissevers the severe tradeoff existing between the input impedance, gain and noise figure, and produces a flat S11 across the entire band. The L#A is composed of a voltage amplifying negative feedback amplifier with a transconductance amplifier forming a shunt-shunt feedbac...
متن کاملDesign of Wideband Low Noise Amplifier using Negative Feedback Topology for Motorola Application
This paper describes the design of wideband low noise amplifier (LNA) for Motorola application which targeted to be applied in two-way communication mobile system architecture. The technical specification was deduced from the TIA-603C standard receiver system sensitivity and intermodulation. The proposed LNA exhibit low power consumption and adopts a negative feedback wideband amplifier topolog...
متن کاملA 0.13μm CMOS Low-Noise Amplifier Using Resistive Feedback Current Reuse Technique for 3.1-10.6 GHz Ultra-Wideband Receivers
Department of Physics and Electronics, University of Science-VNU Hochiminh City, Vietnam; Faculty of Electrical and Electronics Engineering, University of Technology, VNU Hochiminh City, Vietnam; Department of Electrical and Computer Engineering, University of Saskatchewan, Saskatoon, Canada Corresponding Author: Nhan Nguyen ______________________________________________________________________...
متن کامل