2 Method for control gas diffusion and bubbles formation in liquid porosimetry
نویسندگان
چکیده
The main problem in liquid porosimetry, which prevents to see the pore sizes smaller than 2 microns in diameter, is direct gas diffusion flow through a micro-porous membrane. This diffusion causes bubbles formation below the membrane and that spoils extrusion (intrusion) data, as one cannot distinguish the volume of extrusion (intrusion) liquid from the volume of formatted bubbles. The suggested below method cures the problem by creating the liquid flow below the membrane. The flow washes out all of the small bubbles preventing them to grow. That allows using the membrane at higher differential pressures, even higher than minimum bubble point of the membrane, without spoiling data. *
منابع مشابه
A method for detecting bubbles in two-phase gas-liquid flow
Detecting bubble in two-phase flow has been a basic issue in two-phase flow systems. A new method for measuring the frequency of bubble formation is presented in this paper. For this purpose, an electronic device was designed and constructed which works based on a change in intensity of laser beam. For this purpose, continues light beam is embedded just above the needle, which is received by a ...
متن کاملNucleation stage with nonsteady growth of supercritical gas bubbles in a strongly supersaturated liquid solution and the effect of excluded volume.
An approach to the kinetics of barrier formation of supercritical gas bubbles in a strongly supersaturated liquid solution is presented. A common assumption of uniform reduction of a dissolved gas supersaturation in a liquid solution via stationary diffusion to nucleating gas bubbles is shown to be not applicable to the case of high gas supersaturations. The approach recognizes that the diffusi...
متن کاملA method for bubble volume measurement under constant flow conditions in gas–liquid two-phase flow
Measuring the volume of a bubble, especially at its detachment, is a basic subject in gas-liquid two-phase flow research. A new indirect method for this measurement under constant flow conditions is presented. An electronic device is designed and constructed based on laser beam intensity. This device calculates the frequency of the bubble formation by measuring the total time of the formation p...
متن کاملNumerical Analysis of Water and Air in Venturi Tube to Produce Micro-Bubbles
Two-phase flow regimes are affected by conduit position, alignment, geometry, flow direction, physical characteristics, and flow rate of each phase as well as the heat flux toward the boundaries. Due to the importance of two-phase flow, numerous regimes have been identified. The first step in studying micro-bubble formation inside a venturi tube is to recognize the type of flow regimes. In this...
متن کاملAnimation of Bubbles in Liquid
We present a new fluid animation technique in which liquid and gas interact with each other, using the example of bubbles rising in water. In contrast to previous studies which only focused on one fluid, our system considers both the liquid and the gas simultaneously. In addition to the flowing motion, the interactions between liquid and gas cause buoyancy, surface tension, deformation and move...
متن کامل