Peak to Average Power Ratio Reduction in Mc Cdma System by Using Pulse Shaping Technique
نویسندگان
چکیده
One of the drawback of multicarrier code division multiple access (MC CDMA) is the high peak to average power ratio (PAPR). In this paper A novel scheme based on pulse shaping described for PAPR reduction. Here three different pulse shaping filters (Raised cosine, Sinc power pulse and Nyqist pulse) are described for PAPR reduction in MC CDMA system. The method is based on the proper selection of the pulses for shaping the different sub carriers of the MC CDMA modulation scheme. It is shown by computer simulation that the scheme achieves the significant improvement in PAPR reduction in MC CDMA system. Its implementation complexity is much low in comparison to the previous published methods. Thus pulse shaping technique can be used not only to shape the spectrum of the transmitted signal but also to reduce its PAPR. In computer simulation It is observed that by using nyquist pulse near about 6.8 db PAPR is obtained. Which is considerable PAPR reduction than a PAPR value of Original MC CDMA signal
منابع مشابه
Performance Comparison Of Different Pulse Shaping Filters In PAPR Reduction In Multi Carrier Code Division Multiple Access Systems
Future wireless mobile systems are required to transport multimedia traffics at much higher bit rates. Multicarrier (MC) code division multiple access (CDMA) has emerged as a powerful candidate due to its capabilities of achieving high capacity over frequency selective fading channel. It inherits the substantial advantages from both the orthogonal frequency division multiplexing (OFDM) and code...
متن کاملPerformance Improvement in OFDM System by PAPR Reduction Using Pulse Shaping Technique
Orthogonal Frequency Division Multiplexing (OFDM) is an efficient method of data transmission for high speed communication systems. However, the main drawback of OFDM system is the high Peak to Average Power Ratio (PAPR) of the transmitted signal. OFDM consist of large number of independent subcarriers, as a result of which the amplitude of such signal can have high peak values. Pulse shaping u...
متن کاملPAPR Reduction of an MC-CDMA system using SLM technique
Multicarrier Code Division Multiple Access is the most promising technique for high speed data transmission. However, the MC-CDMA signals are characterized by large peak to average power ratios (PAPR), which can reduce the system efficiency. In this paper PAPR reduction of an MCCDMA system using SLM technique is investigated for different modulation schemes. The binary phase sequences considere...
متن کاملPAPR Reduction of an MC-CDMA System through PTS Technique using Suboptimal Combination Algorithm
Multicarrier Code Division Multiple Access is the most promising technique for high speed data transmission. However, the MCCDMA signals are characterized by large peak to average power ratios (PAPR), which can reduce the system efficiency. In this paper PAPR reduction of an MC-CDMA system using PTS technique is investigated by using suboptimal combination algorithm, which uses binary phase fac...
متن کاملPeak-to-Average Power Ratio Analysis of SCFDMA Signal by Hybrid Technique
The low peak-to-average power ratio (PAPR) in single-carrier systems has motivated the Long Term Evolution (LTE) Third Generation Partnership Project (3GPP) to adopt single carrier frequency division multiple access (SC-FDMA) as the uplink multiple access scheme. In this paper, an enhancement of a SC-FDMA system by decreasing the PAPR is focused. A combination of clipping and Pulse shaping (RRC...
متن کامل