Fuzzy Based Design Optimization To Reduce The Crosstalk In Microstrip Lines

نویسندگان

  • T. Ahmad
  • M. Alamgir Hossain
  • A. K. Ray
  • Zabih Ghassemlooy
چکیده

T. AHMAD • Department of Mathematics, Faculty of Science, University of Technology Malaysia, 81310 Skudai, Johor, Malaysia. • Electronics Research Group, School of Engineering, Sheffield Hallam University, City Campus, Pond Street, Sheffield S1 1WB, UK M. A. HOSSAIN • Department of Computing, University of Bradford, Bradford BD7 1DP, UK. • Electronics Research Group, School of Engineering, Sheffield Hallam University, City Campus, Pond Street, Sheffield S1 1WB, UK A. K. RAY • Electronics Research Group, School of Engineering, Sheffield Hallam University, City Campus, Pond Street, Sheffield S1 1WB, UK Z. GHASSEMLOOY • Electronics Research Group, School of Engineering, Sheffield Hallam University, City Campus, Pond Street, Sheffield S1 1WB, UK Received: 31 March 2002 Revised: 31 March 2003

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Crosstalk Mitigation and Impedance Management Using Tabbed Lines

As the demand for low-cost electronic systems increases, increasing wiring density/reducing printed circuit board (PCB) layer count becomes inevitable. This reality limits the PCB routing layer options of high-speed input/output (I/O) signals, making it more difficult to meet the next-generation product’s performance targets. For example, using densely wired microstrip routing on a PCB helps re...

متن کامل

Dual-Frequency Probe-Fed Rectangular Microstrip Antenna Design Using a Fuzzy Approach

-Dual frequency operation of antennas has become a necessity for many applications in wireless communication systems such as GPS, GSM services operating at two different frequency bands and services of PCS and IMT-2000 applications. Although there are various techniques to achieve dual-band operation from various types of microstrip antennas, there is no efficient design tool that has been inco...

متن کامل

A New Switched Reluctance Motor Design to Reduce Torque Ripple using Finite Element Fuzzy Optimization

This paper presents a new design to reduce torque ripple in Switched Reluctance Motors (SRM). Although SRM possesses many advantages in terms of motor structure, it suffers from large torque ripple that causes problems such as vibration and acoustic noise. The paper describes new rotor and stator pole shapes with a non-uniform air gap profile to reduce torque ripple while retaining its average ...

متن کامل

Design of a Two Octave Gysel Power-Divider Using DGS and DMS

This paper proposes a two way L and S band Gysel power divider/combiner that uses line to ground resistors. Step by step methods to obtain a wide isolation and transmission bandwidth are presented. A design that uses five resistors is selected and optimized based on Quasi Newton method. Then the Defected Microstrip Structure (DMS) and Defected Ground Structure (DGS) is used to obtain better tra...

متن کامل

AN OPTIMAL FUZZY SLIDING MODE CONTROLLER DESIGN BASED ON PARTICLE SWARM OPTIMIZATION AND USING SCALAR SIGN FUNCTION

This paper addresses the problems caused by an inappropriate selection of sliding surface parameters in fuzzy sliding mode controllers via an optimization approach. In particular, the proposed method employs the parallel distributed compensator scheme to design the state feedback based control law. The controller gains are determined in offline mode via a linear quadratic regular. The particle ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Journal of Circuits, Systems, and Computers

دوره 13  شماره 

صفحات  -

تاریخ انتشار 2004