RFC 4368 MPLS LC ATM and FR MIBs January 2006 3
نویسنده
چکیده
This memo defines two MIB modules and corresponding MIB Object Definitions that describe how label-switching-controlled Frame-Relay and Asynchronous Transfer Mode (ATM) interfaces can be managed given the interface stacking as defined in the MPLS-LSR-STD-MIB and MPLS-TE-STD-MIB.
منابع مشابه
RFC 4381 Security of BGP / MPLS IP VPNs February
This document analyses the security of the BGP/MPLS IP virtual private network (VPN) architecture that is described in RFC 4364, for the benefit of service providers and VPN users. The analysis shows that BGP/MPLS IP VPN networks can be as secure as traditional layer-2 VPN services using Asynchronous Transfer Mode (ATM) or Frame Relay. Behringer Informational [Page 1] RFC 4381 Security of BGP/M...
متن کاملMPLS using LDP and ATM VC Switching
The Multiprotocol Label Switching (MPLS) Architecture [1] discusses a way in which Asynchronous Transfer Mode (ATM) switches may be used as Label Switching Routers. The ATM switches run network layer routing algorithms (such as Open Shortest Path First (OSPF), Intermediate System to Intermediate System (IS-IS), etc.), and their data forwarding is based on the results of these routing algorithms...
متن کاملRFC 4717 Encapsulation for ATM over MPLS December
Status of This Memo This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited. Abstract An Asynchronous Transfer Mode (A...
متن کاملDesign of a Label Switch Controller for Differentiated Services in IP and ATM Integrated Networks
MPLS is highlightened as the most promising technology for the integrated IP-over ATM backbone networks. Nowadays, one of the important practical issues in MPLS is the capability to provide Differentiated Services. For integrating IP and ATM with scalability, MPLS based ATM switch network can be available, especially for the fast Internet services adding Layer 3 routing module to the existing A...
متن کاملRFC 5129 ECN for MPLS
RFC 3270 defines how to support the Diffserv architecture in MPLS networks, including how to encode Diffserv Code Points (DSCPs) in an MPLS header. DSCPs may be encoded in the EXP field, while other uses of that field are not precluded. RFC 3270 makes no statement about how Explicit Congestion Notification (ECN) marking might be encoded in the MPLS header. This document defines how an operator ...
متن کامل