Modelling the Microstructure of Martensitic Steels
نویسنده
چکیده
A method based on the kinetics of crystal growth has been developed and applied to the computation of three-dimensional microstrucuture in austenite-matensite steels. The detailed crystallography of the transformation is used to model a realistic martensitic microstrucuture during the transformation without an external system of stresses. The interaction energy based on the plastic work model is taken into account to compute the variant selection in an austenitic stainless steel and formation of martensite under externally applied stress.
منابع مشابه
Transient liquid phase bonding of AISI 304L stainless steels with the austenitic and martensitic microstructures
In the present study, the effect of time and base metal microstructure on the Transient Liquid Phase (TLP) bonding of 304L stainless steel was studied. TLP was performed at 1050 0C for 5 and 60 minutes on the coarse grain austenitic and martensitic microstructure using BNi-2 interlayer. To prepare martensitic microstructure, as-received 304L was rolled at -15 0C up to 80% rolling reduction. TEM...
متن کاملTransient liquid phase bonding of AISI 304L stainless steels with the austenitic and martensitic microstructures
In the present study, the effect of time and base metal microstructure on the Transient Liquid Phase (TLP) bonding of 304L stainless steel was studied. TLP was performed at 1050 0C for 5 and 60 minutes on the coarse grain austenitic and martensitic microstructure using BNi-2 interlayer. To prepare martensitic microstructure, as-received 304L was rolled at -15 0C up to 80% rolling reduction. TEM...
متن کاملMicrostructure and Mechanical Properties of Cold Rolled AISI 304L and 316L Austenitic Stainless Steels during Reversion Annealing
Microstructural evolutions during annealing of cold rolled AISI 304L and AISI 316L stainless steels were studied. Cold rolled AISI 304L alloy was fully martensitic but cold rolled AISI 316L alloy was partially martensitic due to the higher stability of the austenite phase in the latter. During continuous heating to elevated temperatures, the complete reversion of strain-induced martensite at 75...
متن کاملModelling of Kinetics and Dilatometric Behavior of Non-isothermal Pearlite-to-austenite Transformation in an Eutectoid Steel
Austenitization is an inevitable occurrence during the heat treatment of steels. Despite this consideration, less attention has been paid so far to the study of the formation of austenite as compared with the vast amount of research on its decomposition. That is because the steel properties depend basically on the transformation processes following austenitization. However, the initial austenit...
متن کاملCrystallographic Analysis of Lath Martensite in Ferrite-Martensite Dual Phase Steel Sheet Annealed after Cold-Rolling
The martensite steels produced by quenching and tempering has been used for machine structural use. Martensite in ferrite-martensite dual-phase steels (hereinafter, DP steels) also has important roll in strengthening of the automobile steel sheets. Therefore the importance of analyzing the microstructure and their mechanical properties of the martensite has been increased year by year. Many res...
متن کامل