Combined radiocarbon and CO2 flux measurements used to determine in situ chlorinated solvent mineralization rate.

نویسندگان

  • T J Boyd
  • M T Montgomery
  • R H Cuenca
  • Y Hagimoto
چکیده

A series of combined measurements was made at the Naval Air Station North Island (NASNI) Installation Restoration Site 5, Unit 2 during July and August 2013. Combined measurements included CO2 respiration rate, CO2 radiocarbon content to estimate chlorinated hydrocarbon (CH) mineralization and a zone of influence (ZOI) model. CO2 was collected continuously over 2 two-week periods by recirculating monitoring well headspace gas through NaOH traps. A series of 12 wells in the main CH plume zone and a background well with no known historical contamination were sampled. The background well CO2 was used to determine radiocarbon content derived from respired natural organic matter. A two end-member mixing model was then used to determine the amount of CH-derived carbon present in the CO2 collected from plume region wells. The ZOI model provided an estimate for the soil volume sampled at each well. CH mineralization rates were highest upgradient and at the plume fringe for areas of high historical contamination and ranged from 0.02 to 5.6 mg CH carbon per day. Using the ZOI model volume estimates, CH-carbon removal ranged from 0.2 to 32 mg CH-carbon m(-3) per day. Because the rate estimates were based on a limited sampling (temporally), they were not further extrapolated to long-term contaminant degradation estimates. However, if the site manager or regulators required them, estimates - subject to long-term variability uncertainties - could be made using volume and rate data determined over short timescales. A more comprehensive seasonal sampling is needed to constrain long-term remediation models for the entire impacted area and identify environmental conditions related to more rapid turnover times amongst the wells.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Isotopic and geochemical assessment of in situ biodegradation of chlorinated hydrocarbons.

Currently there is no in situ method to detect and quantify complete mineralization of chlorinated hydrocarbons (CHCs) to CO2. Combined isotopic measurements in conjunction with traditional chemical techniques were used to assess in situ biodegradation of trichloroethylene (TCE) and carbon tetrachloride (CT). Vadose zone CHC, ethene, ethane, methane, O2, and CO2 concentrations were analyzed usi...

متن کامل

Radiocarbon--a low-impact tool to study nutrient transport by soil fungi under field conditions.

Here, we present a new in-situ method to study the uptake of amino acids by soil fungi. We injected 14C-labeled glycine into a marshland soil and measured the rate and the 14C signature of CO2 respired from sporocarps of Pholiota terrestris over 53.5 h and 2 m. We also determined the incorporation of glycine-C into sporocarp tissue. The 14C signature of the CO2 and tissue was quantified by acce...

متن کامل

Mass Transfer Modeling of CO2 Absorption into Blended MDEA-MEA Solution

In this research, the thermodynamics and mass transfer of CO2 absorption has been studied in a mixture of MDEA-MEA amines. A relation is presented for mass transfer flux in the reactive-absorption process. For this purpose, the effective parameters on the mass transfer flux were investigated in both liquid and gas phases. Then, using dimensional analysis with the Pi-Buckingham theorem, the effe...

متن کامل

Quantitative Comparison of In Situ Soil CO2 Flux Measurement Methods

Development of reliable regional or global carbon budgets requires accurate measurement of soil CO2 flux. We conducted laboratory and field studies to determine the accuracy and comparability of methods commonly used to measure in situ soil CO2 fluxes. Methods compared included two static techniques, sodium hydroxide (NaOH) and soda lime as CO2 traps; a multichamber open dynamic system (OC) wit...

متن کامل

Polyvinylidene Fluoride Hollow Fiber Membrane Contactor Incorporating Surface Modifying Macromolecule for Carbon Dioxide Stripping from Water

Porous surface modified polyvinylidene ï‌‚uoride (PVDF) hollow fiber membranes are fabricated through a dry-wet phased inversion process. Surface modifying macromolecules (SMM) (1 wt. %) are used as additives in the spinning dope. The performance of the surface modified membrane in contactor application for CO2 stripping from water is assessed through the fabricated gas–liquid membrane contacto...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Environmental science. Processes & impacts

دوره 17 3  شماره 

صفحات  -

تاریخ انتشار 2015