Design of multi-frequency microstrip antennas using multiple rings
نویسندگان
چکیده
An electromagnetically coupled feed arrangement is proposed for simultaneously exciting multiple concentric ring antennas for multi-frequency operation. This has a multi-layer dielectric configuration in which a transmission line is embedded below the layer containing radiating rings. Energy coupled to these rings from the line beneath is optimised by suitably adjusting the location and dimensions of stubs on the line. It has been shown that the resonant frequencies of these rings do not change as several of these singlefrequency antennas are combined to form a multi-resonant antenna. Furthermore, all radiators are forced to operate at their primary mode and some harmonics of the lower resonant frequency rings appearing within the frequency range are suppressed when combined. The experimental prototype antenna has three resonant frequencies at which it has good radiation characteristics.
منابع مشابه
Determination of Resonance Frequency of Dominant and Higher Order Modes in Thin and Thick Circular Microstrip Patch Antennas with Superstrate by MWM (RESEARCH NOTE)
An accurate model named as the Modified Wolff Model (MWM) is presented as an efficient CAD tool for determination of resonant frequency of the dominant and higher order modes under the multi-layer condition in thin and thick circular microstrip patch antennas. The effects of dielectric cover on the resonant frequency obtained from MWM have been compared against the result of theoretical method ...
متن کاملAntenna Miniaturization Using Fractals (RESEARCH NOTE)
Antenna Miniaturization Using Fractals Richa Garg, AP ECE Deptt., [email protected], J.C.D.C.O.E., Sirsa ABSTRACTThe use of fractal geometry in designing antenna has been a resent topic of interest. Fractal shape has their own unique characteristics that the improved antenna performance can be achieved without degrading the antenna properties. Modern telecommunication system requires antenn...
متن کاملConical Conformal Antenna Design using the CPM Method for MIMO Systems
Abstract- In this article, the design of conformal antennas has been discussed using the characteristic modes (CM) method. For this purpose, the vector wave function(VWF) has been utilized to achieve a two-dimensional mapping of the conformal antenna. In designing and analyzing of cone-shaped antennas applicable for multi-input multi-output (MIMO) systems, the most important goal is to achieve ...
متن کاملLow-cost Vector Network Analyzer for Biomedical Applications
A low-cost and portable vector network analyzer (VNA) which covered operating frequency between 1MHz to 3GHz is used for vector reflection coefficient and standing wave ratio (swr) of the various microstrip antennas. This paper presents measurements of various ultra wideband (uwb) microstrip antennas for applications in biomedical field. Selection of antenna is an important key for detection of...
متن کاملDual-Frequency Probe-Fed Rectangular Microstrip Antenna Design Using a Fuzzy Approach
-Dual frequency operation of antennas has become a necessity for many applications in wireless communication systems such as GPS, GSM services operating at two different frequency bands and services of PCS and IMT-2000 applications. Although there are various techniques to achieve dual-band operation from various types of microstrip antennas, there is no efficient design tool that has been inco...
متن کامل