Performance Comparison of Al–Ti Master Alloys with Different Microstructures in Grain Refinement of Commercial Purity Aluminum
نویسندگان
چکیده
Three types of Al-5Ti master alloys were synthesized by a method of thermal explosion reaction in pure molten aluminum. Performance comparison of Al-5Ti master alloy in grain refinement of commercial purity Al with different additions (0.6%, 1.0%, 1.6%, 2.0%, and 3.0%) and holding time (10, 30, 60 and 120 min) were investigated. The results show that Al-5Ti master alloy with blocky TiAl₃ particles clearly has better refining efficiency than the master alloy with mixed TiAl₃ particles and the master alloy with needle-like TiAl₃ particles. The structures of master alloys, differing by sizes, morphologies and quantities of TiAl₃ crystals, were found to affect the pattern of the grain refining properties with the holding time. The grain refinement effect was revealed to reduce markedly for master alloys with needle-like TiAl₃ crystals and to show the further significant improvement at a longer holding time for the master alloy containing both larger needle-like and blocky TiAl₃ particles. For the master alloy with finer blocky particles, the grain refining effect did not obviously decrease during the whole studied range of the holding time.
منابع مشابه
Microstructure and Grain Refining Performance of a New Al-Ti-C Master Alloy (RESEARCH NOTE)
Control of microstructure parameters that affecting the Al-Ti-C master alloys grain refining efficiency is leading to improve the aluminum grain refinement. This study was an attempt to produce Al-Ti-C master alloys that provide these controlling factors with relying on the solute effect theory. The produced master alloys were examined by using scanning electron microscopy (SEM), energy-dispers...
متن کاملGrain Refinement Efficiency in Commercial-Purity Aluminum Influenced by the Addition of Al-4Ti Master Alloys with Varying TiAl3 Particles
A series of Al-4Ti master alloys with various TiAl₃ particles were prepared via pouring the pure aluminum added with K₂TiF₆ or sponge titanium into three different molds made of graphite, copper, and sand. The microstructure and morphology of TiAl₃ particles were characterized and analyzed by scanning electron microscope (SEM) with energy dispersive spectroscopy (EDS). The microstructure of TiA...
متن کاملEffect of Material and Process Atmosphere in the Preparation of Al-Ti-B Grain Refiner by SHS
Al-Ti-B master alloys are widely used in the aluminum industry as grain refiners for the control of the microstructure of the aluminum alloys. The SHS (self-propagating high-temperature synthesis) is an ex situ method that uses exothermic reactions to sustain the chemical reaction in a combustion wave. The advantages of SHS are the low energy requirement, simplicity and product purity. However,...
متن کاملDIFFICULTIES IN GRAIN REFINING ALUMINUM LITHIUM ALLOYS USING COMMERCIAL Al-Ti AND Al-Ti-Bor MASTER ALLOYS
High strength aluminum alloys, especially those containing zirconium, are historically difficult to grain refine. Early efforts by Alcoa indicated that the addition of lithium to these alloys increases difficulty with grain refinement. Although grain refining of alloys 2090 and 2091 was possible, consistent results were not obtained. Statistically-designed experiments were used to quickly ident...
متن کامل“ Microstructural and mechanical properties of eutectic Al – Si alloy with grain refined and modified using gravity - die and sand casting ”
This paper attempts to investigate the influence of the microstructure and mechanical property changes on sand casting and permanent die casting alloys by grain refinement, modification combined action of both (Al– 3Ti–1B + Al–10Sr) and without grain refinement and modification effect. The microstructures of the castings are studied by optical microscopes. The microstructure and mechanical prop...
متن کامل