Models of Hysteresis in Magnetic Cores
نویسندگان
چکیده
A new method of obtaining physical information about a system of fme fenite powder, from the hysteresis experienced by a ferromagnetic core as it dissipates energy in an RLC circuit is presented. The models of the magnetization processes are classified in three categories: physical, phenomenological and mixed. Hodgdon developed a purely mathematical model that was tested on magnetization processes in magnetic cores. The values of the model's parameters are calculated l?om experimental data obtained in a series RLC circuit. The capacitor discharges through the circuit and the core performs a complex magnetization process. The voltage across the capacitor and the current intensity are measured. These magnetization pmcesses could be also simulated with a mixed-type model. The identification methodology of the mixed model requires the measurement of some magnetization curves: the first magnetization curve, the major hysteresis loop, the isothermal remanent magnetization process and the d.c. demagnetization process. In order to preserve the simplicity of the experimental data measurement and to perform the identification of the mixed model, some of the experimental curves required by the identification methodology were simulated with the Hodgdon model. Experiments were performed on soft MnZn fenite core. The results of the identification are discussed.
منابع مشابه
Nonlinear Model of Tape Wound Core Transformers
Recently, tape wound cores due to their excellent magnetic properties, are widely used in different types of transformers. Performance prediction of these transformers needs an accurate model with ability to determine flux distribution within the core and magnetic loss. Spiral structure of tape wound cores affects the flux distribution and always cause complication of analysis. In this paper, a...
متن کاملEffect of Heat Treatment Time on the Characteristics of Coating Formed on Nanocrystalline Finemet Foils
In the present research, amorphous Fe73.5Si13.5B9Nb3Cu1 Finemet foils, 21-26µm in thickness and 5mm in width, were prepared by Planar Flow Casting (PFC) process. Wound cores of amorphous Finemet foils were simultaneously annealed and heat treated at 540°C for 60, 120 and 240 minutes in steam and air flow to form oxide insulating coating layer on both surfaces of the foils. The structure of nano...
متن کاملMicrosoft Word - part_6_1
Introduction The models of magnetic devices having a magnetic core without known parameters require the core evaluation by means of sophisticated measurement procedures and systems. For certain models, higher measurement accuracy is of key importance. For the other models, additional factors (speed, cost, measurement instruments and apparatus) may strongly limit achievement of the specific meas...
متن کاملمدلسازی پدیده فرورزونانس در ترانسفورماتورها با استفاده از مدل جدید هیسترزیس هست
Based on the Preisach theory in hysteresis, this paper presents a novel transformer core model. Unlike existing mathematical-based hysteresis models, the proposed model is based on a physically correct hysteresis model and can precisely represent the actual behaviors of magnetic materials. In addition, the experimental results of a ferroresonance test of a Voltage Transformer (VT) are presented...
متن کاملEffect of Cold Rolling sequence on the Texture Development and Magnetic Loss of Grain Oriented Electrical Steels
Electrical steels are important alloys widely used in electrical instruments. The magnetic properties and low core loss of grain oriented silicon steels are closely related to the sharpness of Goss texture ({110} ).The direction of is the softest direction for magnetism. In this work, the microstructure and dependence of orientation density along the major texture fibers on the applied cold ro...
متن کامل