Investigation of the Effect of Fused Deposition Process Parameter on Compressive Strength and Roughness Properties of Abs-M30 Material
نویسندگان
چکیده
The process parameters of FDM manufacturing technology are very important for obtaining high quality parts, good mechanical properties. Several optimization techniques used such as Response surface methodology, Taguchi method, FF, ANN etc. much research work has been carried out in ABS, PC, PPSF, Nylon-12, PC-ABS blend for optimizing process parameters to identify improved surface roughness, mechanical properties and built-up time.
منابع مشابه
Investigation of Rapid Manufacturing Technology Effect on Aerodynamics Properties
Original scientific paper Nowadays, rapid manufacturing methods are widely used in order to produce wind tunnel test models. Dimension accuracy, surface roughness and material strength are important parameters affecting aerodynamic properties of the models. In this research, applications and capabilities of two rapid manufacturing methods used in design and development of wind tunnel test model...
متن کاملFinishing of ABS-M30 Parts Manufactured with Fused Deposition Modeling With Focus on Dimensional Accuracy
Fused Deposition Modeling (FDM) parts are prone to process-related rough and wavy surfaces with stair-stepping effects whenever the parts produced have sloped or rounded geometries. These stair-stepping effects can be reduced by using a smaller slice height, but complete elimination is not possible. In this paper, FDM parts manufactured with the material ABS-M30 are finished using mass finishin...
متن کاملInvestigation of the mechanical properties of cold roll welded Brass and IF steelproduced by cold roll bonding process
Cold roll bonding (CRB) is a solid state welding process, where the bonding is established by compressive plastic deformation of the metals. This process is applicable for a large number of materials. In addition, materials that cannot be bonded by traditional fusion-based processesmight be bonded by CRB process. In this research, cold roll welding of brass and IF steel was studied .The effects...
متن کاملEffect of Temperature and Gas Flux on the Mechanical Behavior of TiC Coating by Pulsed DC Plasma Enhanced Chemical Vapor Deposition(TECHNICAL NOTE)
There are many factors such as voltages, duty cycle, pressure, temperatures and gas flux in coatings process that were effective in changing coatings characteristic. In this paper in plasma enhanced chemical vapor deposition (PECVD) technique, temperature and gas flux are two important variants that affecting the coatings structure and mechanical properties. All TiC coating deposited on a hot...
متن کاملInvestigation of the mechanical properties of cold roll welded Brass and IF steelproduced by cold roll bonding process
Cold roll bonding (CRB) is a solid state welding process, where the bonding is established by compressive plastic deformation of the metals. This process is applicable for a large number of materials. In addition, materials that cannot be bonded by traditional fusion-based processesmight be bonded by CRB process. In this research, cold roll welding of brass and IF steel was studied .The effects...
متن کامل