Pii: S1359-6454(98)00380-2

نویسندگان

  • I. STEINBACH
  • J. GUO
چکیده

ÐA novel mesoscopic modeling technique has been developed to simulate the unsteady growth of multiple equiaxed dendritic grains into a supercooled melt of a pure substance. In the model, the numerical calculation of the temperature ®eld in the supercooled melt between the grains is coupled with a stagnant®lm model for dendrite tip growth, such that without resolving individual dendrite arms the evolution of the grain envelope and the internal solid fraction can be predicted. The simulations are in good agreement with experiments for the growth of a single dendritic grain of the model substance succinonitrile. The model is then applied to simulate the growth of various con®gurations of up to 14 strongly interacting grains. The results indicate that the use of local analytical solutions in numerical calculations is a viable technique for simulating large-scale dendritic growth phenomena. # 1999 Acta Metallurgica Inc. Published by Elsevier Science Ltd. All rights reserved.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Pii: S1359-6454(99)00264-5

ÐThe grain boundary segregation of Bi in dilute polycrystalline Cu±Bi alloys was systematically studied as a function of temperature and composition. The temperature dependencies of the Gibbsian excess of Bi at the grain boundaries exhibited discontinuous changes at the temperatures close to, but di€erent from the bulk solidus temperatures. The observed segregational phase transition was interp...

متن کامل

Pii: S1359-6454(98)00345-0

ÐIn current design the circuitry is extended very close to the edges of a silicon die to maximize useful surface area. When the die is bonded to a polymer substrate, with the circuitry facing the polymer, thermal mis®t stress concentrates at the die edges and may damage the circuitry. The stress distribution near a die edge is quanti®ed using a combination of asymptotic analysis and ®nite eleme...

متن کامل

Pii: S1359-6454(96)00395-3

Debonding of films attached to substrates as well as fibers embedded in matrices typically involves initiation, steady-state propagation and a final transient as the debond converges on an edge or another debond. The emphasis in this paper is on the mechanics of the transient. Under most circumstances, a converging debond crack is characterized by an energy release rate that approaches zero, ca...

متن کامل

Pii: S1359-6454(98)00428-5

ÐAn unstable, f.c.c. Fe50Cu50 solid solution was prepared using high-energy ball milling of an elemental powder mixture. It was used as a parent alloy for isothermal annealing or low-energy ball milling (LEBM), both at 373±523 K. Alloy evolution was analyzed by X-ray di€raction, MoÈ ssbauer spectroscopy and di€erential scanning calorimetry. LEBM signi®cantly enhanced the initial decomposition r...

متن کامل

Pii: S1359-6454(99)00156-1

ÐThe e€ect of hydrogen in solid solution on the edge/screw character of dislocations has been investigated by deforming samples of high-purity aluminum in a gaseous hydrogen environment in situ in a controlled environment transmission electron microscope. Solute hydrogen was found to stabilize edge segments of dislocations, which inhibited, and in some cases stopped dislocations from cross-slip...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 1999