Anisotropic electrical resistivity during annealing of oriented columnar titanium films
نویسنده
چکیده
We report on the evolution of anisotropic electrical resistivity versus temperature of titanium thin films. An oriented titanium film (1 μm thick) is sputter deposited by GLancing Angle Deposition (GLAD) using an incident angle α = 80° of the particle flux. Two parallel Ti electrodes cover this GLAD film. We measure the components of the conductivity tensor by the van der Pauw method during an annealing treatment in air ranging from 298 to 873 K. The average DC electrical resistivity ρ changes from 6.03×10 to more than 2.40×10 Ωm with the increasing temperature. The anisotropy ratio is A = 1.39 before annealing and reaches 12.4 for the highest temperatures. This enhanced anisotropy is interpreted assuming the oxidation of the porous GLAD titanium film.
منابع مشابه
Magnetic and Electerical Resistivity Behavior of Amorphous Ni Co P Films
Magnetic and Electrical Resistivity Study of Electroless Amorphous Ternary System (Ni-Co-P) show a qualitative dependence of crystalline phases formed during transformation on the annealing temperature and composition. Electrical Resistivity values increases with increase in cobalt content and samples with higher resistivity show lower temperature coefficients. The Initial increase in magnetiza...
متن کاملMetal-to-dielectric transition induced by annealing of oriented titanium thin films
Titanium thin films were deposited by dc magnetron sputtering. The GLancing Angle Deposition (GLAD) method was implemented to prepare two series of titanium films: perpendicular and oriented columnar structures. The first one was obtained with a conventional incidence angle of the sputtered particles ( = 0°), whereas the second one used a grazing incidence angle = 85°. Afterwards, films were an...
متن کاملStructural, Electrical and Optical Properties of Molybdenum Oxide Thin Films Prepared by Post-annealing of Mo Thin Films
Molybdenum thin films with 50 and 150 nm thicknesses were deposited on silicon substrates, using DC magnetron sputtering system, then post-annealed at different temperatures (200, 325, 450, 575 and 700°C) with flow oxygen at 200 sccm (standard Cubic centimeter per minute). The crystallographic structure of the films was obtained by means of x-ray diffraction (XRD) analysis. An atomic force micr...
متن کاملStructural, Electrical and Optical Properties of Molybdenum Oxide Thin Films Prepared by Post-annealing of Mo Thin Films
Molybdenum thin films with 50 and 150 nm thicknesses were deposited on silicon substrates, using DC magnetron sputtering system, then post-annealed at different temperatures (200, 325, 450, 575 and 700°C) with flow oxygen at 200 sccm (standard Cubic centimeter per minute). The crystallographic structure of the films was obtained by means of x-ray diffraction (XRD) analysis. An atomic force micr...
متن کاملEffect of high temperature annealing on the electrical performance of titanium/platinum thin films
In this study, the influence of post deposition annealing steps (PDA) on the electrical resistivity of evaporated titanium/platinum thin films on thermally oxidised silicon is investigated. Varying parameters are the impact of thermal loading with maximum temperatures up to TPDA=700 °C and the platinum top layer thickness ranging from 24 nm to 105 nm. The titanium based adhesive film thickness ...
متن کامل