Laser removal of particles from solid surfaces

نویسندگان

  • Y. F. Lu
  • W. D. Song
چکیده

Laser removal of particles from solid surfaces was investigated both theoretically and experimentally. A cleaning model was established for laser-induced removal of particles from solid surfaces by taking Van der Waals force, capillary force and cleaning force into account. Laser cleaning forces are induced by fast thermal expansion of particles and/or solid surfaces irradiated by laser for dry laser cleaning and evaporating liquid film heated by laser irradiation for steam laser cleaning, respectively. It was found that cleaning efficiency depends on laser fluence, pulse number, wavelength, incident direction and liquid properties. Cleaning thresholds can be obtained by comparing cleaning force and adhesion force. The experimental results are good consistent with theoretical analysis.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Laser removal of oxides and particles from copper surfaces for microelectronic fabrication.

Laser removal of surface oxides and small particles from copper surfaces was carried out using a Q-switched Nd:YAG laser. Oxide layers and small particles on copper surfaces should be removed for the improvement of solder quality on printed circuit boards (PCBs) and for the prevention of circuit failure or loss of production yield during the fabrication of microelectronic devices. A selective r...

متن کامل

Bubble nucleation and pressure generation during laser cleaning of surfaces

Bubble nucleation and growth dynamics, on a nanosecond time scale, induced by pulsed laser heating of a liquid–solid interface are studied experimentally. A surface-plasmon probe is implemented as a novel, highly sensitive method for the study of submicroscopic bubbles, providing accurate information on the nucleation thresholds, growth velocities, and transient pressure generation by rapid bub...

متن کامل

Ultraviolet laser removal of small metallic particles from silicon wafers

Laser removal of small 1mm sized copper, gold and tungsten particles from silicon wafer surfaces was carried out using ultraviolet radiation at 266 nm generated by Nd:YAG harmonic generation. Successful removal of both copper and gold particles from the surface was achieved whereas tungsten particles proved to be difficult to remove. The cleaning efficiency was increased with an increase of las...

متن کامل

Chapter 6 STEAM LASER CLEANING OF SILICON SURFACES: LASER-INDUCED GAS BUBBLE NUCLEATION AND EFFICIENCY MEASUREMENTS

The removal of dust particles from semiconductor surfaces requires new cleaning strategies such as Steam Laser Cleaning (SLC). It is based on laser-induced explosive evaporation of a liquid layer applied on the surface. We have investigated the laser-induced nucleation and growth of gas bubbles at silicon/water, silicon/isopropanol and silver-film/water interfaces by light scattering and surfac...

متن کامل

Facile Synthesis of Nanosized MgO as Adsorbent for Removal of Congored Dye from Wastewate

Nanostructures of magnesium oxide is one of the most attractive materials which have shown various applications in many aspects of industries. So, finding a controllable and inexpensive technique to produce desirable nanostructures of MgO is valuable. In this work, magnesium oxide (MgO) with different morphologies was successfully prepared via a simple solid-state method. The molar ratio of sod...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2001