Effect of hydrofluoric acid (HF) concentration to pores size diameter of silicon membrane.

نویسندگان

  • Norhafizah Burham
  • Azrul Azlan Hamzah
  • Burhanuddin Yeop Majlis
چکیده

This paper studies parameters which affect the pore size diameter of a silicon membrane. Electrochemical etching is performed in characterise the parameter involved in this process. The parameter has been studied is volume ratio of hydrofluoric acid (HF) and ethanol as an electrolyte aqueous for electrochemical etch. This electrolyte aqueous solution has been mixed between HF and ethanol with volume ratio 3:7, 5:5, 7:3 and 9:1. As a result, the higher volume of HF in this electrolyte gives the smallest pore size diameter compared to the lower volume of HF. These samples have been dipped into HF and ethanol electrolyte aqueous with supplied 25 mA/cm2 current density for 20, 30, 40, and 50 minutes. The samples will inspect under Scanning Electron Microscope (SEM) to execute the pore formations on silicon membrane surface.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Area Effect of Reflectance in Silicon ‎Nanowires Grown by Electroless Etching

This paper shows that the reflectance in silicon nanowires (SiNWs) can be optimized as a function of the area of silicon substrate where the nanostructure growth. SiNWs were fabricated over four different areas of silicon substrates to study the size effects using electroless etching technique. Three different etching solution concentrations of silver nitrate (AgNO3) and hydroflu...

متن کامل

Formation of straight 10 nm diameter silicon nanopores in gold decorated silicon.

We observe pore formation with diameters in the 10 nm range in silicon when it is covered with gold particles. This pore etching occurs when the sample is put in 5 wt % hydrofluoric acid (HF) solution for a few minutes. The pores form along the 100 direction, which is also the preferred direction of macro- and mesopores electrochemically etched into silicon. No etching occurs if the dissolved o...

متن کامل

Effect of hydrofluoric acid concentration and etching time on the surface roughness of CAD/CAM ceramics

Introduction: Dental ceramics are considered as materials that can restore the appearance of natural teeth. Etching the inner surface of a ceramic restoration with hydrofluoric acid (HF) followed by using a silane coupling agent is a well-known and recommended method to increase the bond strength. The aim of etching on ceramic structure is to enhance the surface roughness (Ra) and energy and to...

متن کامل

Characterization and adsorption properties of diatomaceous earth modified by hydrofluoric acid etching.

This work was a study of the chemical modification of diatomaceous earth (DE) using hydrofluoric acid (HF) solution. Under the experimental conditions investigated, it was found that HF under controlled conditions significantly etched inward into the interior of the existing pore structure in the clay mineral due to its high content of silica, leaving a framework possessing a larger BET surface...

متن کامل

Preparation of Luminescent Silicon Nanoparticles by Photothermal Aerosol Synthesis Followed by Acid Etching

CO2 laser-induced pyrolysis of silane (photothermal aerosol synthesis) was used to produce Si nanoparticles. Particles with an average diameter as small as 5 nm were prepared directly from silane in the gas phase. Etching these particles with mixtures of hydrofluoric acid (HF) and nitric acid (HNO3) is shown to be an effective method to reduce the size of the particles produced by silane pyroly...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Bio-medical materials and engineering

دوره 24 6  شماره 

صفحات  -

تاریخ انتشار 2014