Engineering overview of the conceptual design and hardware/software implementation proposed for the Magdalena Ridge Observatory Interferometer
نویسندگان
چکیده
Magdalena Ridge Observatory (MRO) Interferometer is a ten telescope optical interferometer array being built on the Magdalena Mountains 20 miles west of Socorro, New Mexico. The interferometer is being designed by collaboration between New Mexico Institute of Mining and Technology and the University of Cambridge. The science mission and requirements have been finalized which has helped to begin engineering design and development culminating in detailed conceptual designs. Some of the proposed hardware and software implementations are currently being tested in the lab. We present an engineering overview of the conceptual design and the proposed hardware and software implementations.
منابع مشابه
The Conceptual Design of the Magdalena Ridge Observatory Interferometer
We describe the scientific motivation for and conceptual design of the Magdalena Ridge Observatory Interferometer, an imaging interferometer designed to operate at visible and near-infrared wavelengths. The rationale for the major technical decisions in the interferometer design is discussed, the success of the concept is appraised, and the implications of this analysis for the design of future...
متن کاملMagdalena Ridge Observatory Interferometer: The control system of the unit telescopes
This paper describes the telescope control system for the Magdalena Ridge Observatory Interferometer. To achieve the rapid development time required by the project we made use of two software packages, LabVIEW from National Instruments and TCSpk from Tpoint Software. The telescope control system is built from a set of components that conform to a standard interface and implement a set of compon...
متن کاملSoftware Architecture of the Magdalena Ridge Observatory Inteferometer
Merging software from 36 independent work packages into a coherent, unified software system with a lifespan of twenty years is the challenge faced by the Magdalena Ridge Observatory Interferometer (MROI). We solve this problem by using standardized interface software automatically generated from simple highlevel descriptions of these systems, relying only on Linux, GNU, and POSIX without comple...
متن کاملFPGA Implementation of JPEG and JPEG2000-Based Dynamic Partial Reconfiguration on SOC for Remote Sensing Satellite On-Board Processing
This paper presents the design procedure and implementation results of a proposed hardware which performs different satellite Image compressions using FPGA Xilinx board. First, the method is described and then VHDL code is written and synthesized by ISE software of Xilinx Company. The results show that it is easy and useful to design, develop and implement the hardware image compressor using ne...
متن کاملModified 32-Bit Shift-Add Multiplier Design for Low Power Application
Multiplication is a basic operation in any signal processing application. Multiplication is the most important one among the four arithmetic operations like addition, subtraction, and division. Multipliers are usually hardware intensive, and the main parameters of concern are high speed, low cost, and less VLSI area. The propagation time and power consumption in the multiplier are always high. ...
متن کامل