BandPass Sigma-Delta Modulator for wideband IF signals

نویسندگان

  • Luca Daniel
  • Marco Sabatini
چکیده

Sigma-Delta modulation techniques have been applied to narrow-band passband signals [Jantzi93]. Recent technology improvement has allowed conversion of GSM channels [Ong97] and DECT channels[Bazarjiani97]. In this report, the main concept behind BandPass Sigma-Delta conversion is briefly explained together with its advantages and applications. The architecture choices for this design are then discussed. Finally, the main building blocks and the circuit non-idealities are both analyzed analytically and simulated with appropriate tools.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A six-order wideband bandpass sigma-delta modulator

frequency 40MHz with 78dB Dynamic Range in a 0.35µm CMOS process. I. INTRODUCTION Oversampling bandpass A/D is widely used because of its increased accuracy and decreased analog front-end circuitries in transceiver systems. High frequency digital processing is more robust than its analog counterpart, and does not have the analog circuit imperfections. Digital IF extraction is also very benefici...

متن کامل

Time-Mode Signal Quantization for Use in Sigma-Delta Modulators

The rapid scaling in modern CMOS technology has motivated the researchers to design new analog-to-digital converter (ADC) architectures that can properly work in lower supply voltage. An exchanging the data quantization procedure from the amplitude to the time domain, can be a promising alternative well adapt with the technology scaling. This paper is going to review the recent development in t...

متن کامل

Decimation for Bandpass Sigma-Delta Analog-to-Digital Conversion

An efficient means for constructing a narrow bandpass filter for an analogto-digital converter based on a bandpass sigma-delta modulator is presented. It is shown that the filter can be made with very simple hardware, comparable to that required by an analog-to-digital converter using standard lowpass sigma-delta modulation. Introduction Bandpass sigma-delta modulation [1] is a variant of the m...

متن کامل

The Utilization of Novel Bandpass Sigma-delta Modulator for Capacitance Pressure Sensor Signal Processing

The paper deals with a novel approach to processing of pressure sensor signals. A bandpass sigma-delta modulator is used for this purpose. This technique is relatively new and it is not used widely, because this kind of modulator is usually utilized for wireless and video applications. Since the bandpass sigma-delta modulator works within its defined band it is resistant to offsets of its subci...

متن کامل

A 4th-order Bandpass Sigma-delta Modulator

Digital radio receivers must perform the analog-to-digital conversion of bandpass signals. For signals with small relative bandwidths, bandpass XA analog-to-digi ta l converters offer high signal-to-noise ratios at significantly lower sampling rates than are required for lowpass ZA converters, while still providing excellent linearity. A 4thorder bandpass ZA modulator implemented in a 3 pm CMOS...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 1999