CMOS Output Buffer Wave Shaper
نویسندگان
چکیده
Abstract As the switching speeds and densities of Digital CMOS integrated circuits continue to increase, output switching noise becomes more of a problem. This paper reports a novel design technique which aids in the reduction of switching noise. The output driver stage is analyzed through the use of an equivalent RLC circuit. The results of the analysis are used in the design of an output driver stage. A test circuit based on these techniques is being submitted to MOSIS for fabrication.
منابع مشابه
Precision Full-Wave Rectifier Using Two DDCCs
A new precision full-wave rectifier employing only two differential difference current conveyors, which is very suitable for CMOS technology implementation, is presented. The proposed rectifier is the voltage-mode circuit, which offers high-input and low-output impedance hence it can be directly connected to load without using any buffer circuits. PSPICE is used to verify the circuit performanc...
متن کاملA CMOS Buffer Without Short-Circuit Power Consumption
A new CMOS buffer without short-circuit power consumption is proposed. The gatedriving signal of the output pull-up (pull-down) transistor is fed back to the output pull-down (pull-up) transistor to get tri-state output momentarily, eliminating the short-circuit power consumption. The HSPICE simulation results verified the operation of the proposed buffer and showed the power-delay product is a...
متن کاملA CMOS Buffer without Short Circuit Power Consumption for Low Power Application
A new CMOS buffer without short-circuit power consumption is proposed. In this work, the gate-driving signal of the output pull-up (pull-down) transistor is fed back to the output pull-down (pull-up) transistor to get tri-state output momentarily, eliminating the short-circuit power consumption. The TSPICE simulations are used to verify the operation of the buffer. It is observed that the power...
متن کاملA Multimode CMOS Low Noise Amplifier Using Wideband Matching
This paper describes a 0.18 um CMOS wideband multimode LNA for wireless applications, such as WAVE (802.11p), WLAN (802.11a/b/g), WCDMA and Wibro. The circuit topology is a cascode structure with selective input path and wideband output matching for high gain with a low noise figure. By reducing the the quality factor (Q factor) of the narrowband LNA, it can get the flat passband gain. This str...
متن کاملTest and Evaluation of HAL25: The ALICE SSD Front-End Chip
HAL25 is a mixed low noise, low power consumption and radiation hardened ASIC intended for the Silicon Strip Detectors (SSD) read out in the ALICE tracker. It is designed in a 0.25 micron CMOS process. It contains 128 analogue channels, consisting each of a preamplifier, a shaper and a storage capacitor. The analogue data is sampled by an external logic signal and then is serially read out thro...
متن کامل