A Two-stage Inductive Voltage Divider for Coaxial Bridges
نویسندگان
چکیده
The traceability chain to derive the capacitance unit from the quantum Hall resistance coaxial bridges. These bridges employ a inductive voltage divider to provide the voltage ratio needed. One such divider has recently been constructed calibrated at Inmetro. The design techniques responsible for the small ratio errors of the device are detailed
منابع مشابه
Calibration of Multi-decade Inductive Voltage Dividers
Abstract: A method for calibrating multi-decade inductive voltage dividers has been developed which makes it possible to determine both the inphase and the quadrature error for ratios of i /11, i = 1, 2, ..., 10 in the frequency range from 400 Hz to 5 kHz. Calibration is made by comparing the divider under test against a reference two-stage divider having a ratio winding with 11 identical secti...
متن کاملA Capacitance Measurement System Using an IVD Bridge
A new system to characterize the magnitude and phase characteristics of 1 pF to 1 F capacitance standards over the 50 Hz to 100 kHz frequency range is described. The system has been developed to provide measurement support for LCR meters and general impedance measurement services. It consists of an inductive voltage divider (IVD) bridge capable of accurately comparing two capacitance standards...
متن کاملBinary Versus Decade Inductive Voltage Divider Comparison and Error Decomposition
Absbacl-An automatic Inductive Voltage Divider ( I M ) characterization method that can measure linearity by comparing WD’s with differeut structures is suggested. Structural models are employed to decompose an error vector into components that represent each divider. Initial tests at 400 Hz show that it is possible to assign independent errors due to the binary and decade structures with a 27 ...
متن کاملA High Gain and Forward Body Biastwo-stage Ultra-wideband Low Noise Amplifier with Inductive Feedback in 180 nm CMOS Process
This paper presents a two-stage low-noise ultra-wideband amplifier to obtain high and smooth gain in 180nm CMOS Technology. The proposed structure has two common source stages with inductive feedback. First stage is designed about 3GHz frequency and second stage is designed about 8GHz. In simulation, symmetric inductors of TSMC 0.18um CMOS technology in ADS software is used.Simulations results ...
متن کاملEVALUATION OF INDUCTIVE VOLTAGE DIVIDERS AND 10 nF CAPACITORS IN A CAPACITANCE CALIBRATION METHOD
Researchers within the Quantum Electrical Metrology Division at the National Institute of Standards and Technology (NIST) have implemented a calibration procedure for four-terminal-pair capacitance standards from 0.01 μF to 100 μF [1], [2]. This method depends on the accurate characterization of a 1 nF capacitor and an Inductive Voltage Divider (IVD) 1:10 ratio from 100 Hz to 100 kHz. This pape...
متن کامل