Evaluation of a Powered Ankle-Foot Prosthesis during Slope Ascent Gait
نویسندگان
چکیده
Passive prosthetic feet lack active plantarflexion and push-off power resulting in gait deviations and compensations by individuals with transtibial amputation (TTA) during slope ascent. We sought to determine the effect of active ankle plantarflexion and push-off power provided by a powered prosthetic ankle-foot (PWR) on lower extremity compensations in individuals with unilateral TTA as they walked up a slope. We hypothesized that increased ankle plantarflexion and push-off power would reduce compensations commonly observed with a passive, energy-storing-returning prosthetic ankle-foot (ESR). We compared the temporal spatial, kinematic, and kinetic measures of ten individuals with TTA (age: 30.2 ± 5.3 yrs) to matched abled-bodied (AB) individuals during 5° slope ascent. The TTA group walked with an ESR and separately with a PWR. The PWR produced significantly greater prosthetic ankle plantarflexion and push-off power generation compared to an ESR and more closely matched AB values. The PWR functioned similar to a passive ESR device when transitioning onto the prosthetic limb due to limited prosthetic dorsiflexion, which resulted in similar deviations and compensations. In contrast, when transitioning off the prosthetic limb, increased ankle plantarflexion and push-off power provided by the PWR contributed to decreased intact limb knee extensor power production, lessening demand on the intact limb knee.
منابع مشابه
Evaluation of a Viscoelastic Ankle-Foot Prosthesis at Slow and Normal Walking Speeds on an Able-Bodied Subject
Objectives: This paper describes further improvement and preliminarily evaluation of a novel viscoelastic ankle-foot prosthesis prototype. The objective was to control the ankle hysteresis at slow and normal walking speeds. Methods: Inspired by the ankle biomechanics, in which the hysteresis differs based on the gait speeds, a manually damping control mechanism imbedded in the prosthesis for...
متن کاملControl of a powered ankle-foot prosthesis based on a neuromuscular model.
Control schemes for powered ankle-foot prostheses rely upon fixed torque-ankle state relationships obtained from measurements of intact humans walking at target speeds and across known terrains. Although effective at their intended gait speed and terrain, these controllers do not allow for adaptation to environmental disturbances such as speed transients and terrain variation. Here we present a...
متن کاملInitial Experimental Study on Dynamic Interaction Between an Amputee and a Powered Ankle-Foot Prostheses
Today, commercially available ankle-foot prostheses are completely passive, and consequently, their mechanical properties remain fixed with walking speed and terrain. Conversely, normal human ankle stiffness varies within each gait cycle and also with walking speed [1][2][3]. Furthermore, some studies have indicated that one of the main functions of the human ankle is to provide adequate energy...
متن کاملDetection of Gait Modes Using an Artificial Neural Network during Walking with a Powered Ankle-Foot Orthosis
This paper presents an algorithm, for use with a Portable Powered Ankle-Foot Orthosis (i.e., PPAFO) that can automatically detect changes in gait modes (level ground, ascent and descent of stairs or ramps), thus allowing for appropriate ankle actuation control during swing phase. An artificial neural network (ANN) algorithm used input signals from an inertial measurement unit and foot switches,...
متن کاملGait Emulator for Evaluation of Ankle–Foot Prostheses Capable of Turning
One of the challenges in the development of prostheses is the testing and tuning of the mechanism before testing with human subjects. It is a common practice in the industry to use testing platforms to tests new products for different properties such as strength and fatigue; however, few platforms have been developed for testing and tuning of ankle–foot prosthesis. Before testing the lower extr...
متن کامل