Static and Dynamic Lateral Loading of Pile Groups

Harmonic Response of Pile Groups to Dynamic Loading

A completely general method of analysis for three-dimensional raked piles under harmonic excitation is discussed. The piles have been represented by a three-dimensional frame structure and the soil has been represented by a boundary element discretization scheme. A computer program has been written which carries out this analysis and produces a group stiffness matrix that can be included as a f...

Viscoelastic Modeling of the Recovery Behavior of Cut Pile Carpet After Static Loading: A Comparison Between Linearand Nonlinear Models

Evaluation of Static and Dynamic Methods for Determining the Bearing Capacity of the Driven Pipe Piles (TECHNICAL NOTE)

Determination of the pile capacity is always a major concern for the safe geotechnical engineering design. Different direct and indirect methods have been proposed for determining pile bearing capacity such as static and dynamic approaches. Each method depends on the condition of the soil and type of pile as well as accessibility to necessary information. In this study bearing capacity of drive...

Numerical Simulation of Piles Subjected To Lateral Spreading and Comparison with Shaking Table Results

Pile foundations are relatively vulnerable to lateral loads. During liquefaction-induced lateral spreading, this vulnerability is particularly conspicuous due to a loss of strength and stiffness in the liquefied soil. A nonlinear effective stress analysis incorporating an elastoplastic constitutive model based on Finite Difference Method (FLAC2D program) was used to numerically simulate shake t...

Three-dimensional Finite Element Modelling of Dynamic Pile–soil–pile Interaction in Time Domain

Dynamic analysis of embedded foundations like pile groups have received considerable attention in the past. Most existing approaches are established in the frequency domain, not allowing the simulation of material and geometric nonlinearities. In this paper, transient analyses are conducted to calculate the impedance of piles and pile groups, using a full three-dimensional numerical model for b...