European Organisation for Nuclear Research Cern - Ps Division
نویسنده
چکیده
In view of a possible evolution of the CERN accelerator complex towards higher proton intensities, a 2.2 GeV H linac with 4 MW beam power has been designed, for use in connection with an accumulator and compressor ring as proton driver of a muon-based Neutrino Factory. The high-energy part of this linac can use most of the RF equipment (superconducting cavities and klystrons) from the LEP collider after its decommissioning at the end of 2000. Recent results concerning low-beta superconducting cavities are presented, and the main characteristics of the linac design are described. The complete linac-based proton driver facility is outlined, and the impact on the linac design of the requirements specific to a Neutrino Factory is underlined. XX International Linac Conference, 21-25 August 2000, Monterey, CA, USA
منابع مشابه
European Organisation for Nuclear Research Cern - Ps Division
In view of the physics interest, CERN has decided to engage in the study of a Neutrino Factory. The present paper describes our basic concept, and plans for R&D. Presented at NUFACT'00, Monterey, California, USA 22-26 May 2000 Geneva, Switzerland September 2000
متن کاملEUROPEAN ORGANISATION FOR NUCLEAR RESEARCH CERN - PS DIVISION CERN/PS 2001-007 (RF) CERN-NUFACT-Note 074 CURRENT ACTIVITIES FOR A NEUTRINO FACTORY AT CERN
Development is necessary in a large number of technologies before a Neutrino Factory complex can be built. In the case of the CERN project [1, 2, 3], with the help of other laboratories, work is progressing on the systems incorporated in the reference scheme. The subjects under investigation, the status of the studies and the trends of evolution of the scheme are described. HEACC'2001, 26-30 Ma...
متن کاملEUROPEAN ORGANIZATION FOR NUCLEAR RESEARCH ORGANISATION EUROPEENNE POUR LA RECHERCHE NUCLEAIRE CERN PS DIVISION CERN PS 2001-065(BD) N2 and Xe Gas Scintillation Cross-Section, Spectrum, and Lifetime Measurements from 50 MeV to 26 GeV at the CERN PS and Booster
Beam parameters in CERN’s Proton Synchrotron (PS) accelerator must be controlled (and measured) with tighter precision than ever before to meet the stringent requirements of the Large Hadron Collider (LHC) programme. A non-destructive beam profile measurement system would be a valuable diagnostic tool. To this end, we measured N2 and Xe gas scintillation absolute cross-sections and lifetimes fo...
متن کاملEUROPEAN ORGANISATION FOR NUCLEAR RESEARCH CERN – PS DIVISION CERN/PS 2001-049 (PP) CERN NUFACT Note 083 STATUS OF STUDIES FOR A MUON COOLING EXPERIMENT
A possible layout for a cooling experiment is being studied to demonstrate the feasibility of the CERN reference scenario for a muon cooling channel of a future neutrino factory. Tracking of muons in 3D magnetic and electric fields was performed with the aim of validating the set-up, i.e. the possibility of extrapolating to the final reference channel. Simulation results are shown together with...
متن کاملEUROPEAN ORGANISATION FOR NUCLEAR RESEARCH CERN – PS DIVISION CERN NUFACT Note 084 CERN/PS 2001-050 (RF) DESIGN OF THE SUPERCONDUCTING SECTION OF THE SPL LINAC AT CERN
In order to set up a powerful proton source for a future Neutrino Factory, increasing at the same time the flux of protons available for new and existing facilities, CERN is studying a 2.2 GeV superconducting Hlinac for 4 MW beam power, called SPL. The superconducting part of this linac covers the energy range from 120 MeV to 2.2 GeV. Three sections made of 352 MHz cavities with nominal ß of 0....
متن کامل