Preparation and Evaluation of Bonded Linear Polymethacrylate Stationary Phases for Open Tubular Capillary Electrokinetic Chromatography

A new procedure for the preparation of thick polymethacrylate films bonded in 25 μm i.d. fused-silica capillaries is developed. The etched silica surface is first modified with an unsaturated organosilane, which is later incorporated into the polymer film. The capillary is then filled with a monomer solution, and polymerization is initiated by incubation at elevated temperature. This thermoinitiation method enables the use of ordinary polyimide-jacketed capillaries in preparing the columns. The effect of monomer concentration on the resulting polymer film was studied by open tubular capillary electrokinetic chromatography using p-hydroxybenzoates (parabens) as test solutes. Good separations were achieved using short capillaries. Run-to-run retention time reproducibility was excellent, with RSDs of 2% (n ) 50) being representative. For the linear polymer films produced, retention of analytes increased as the monomer concentration increased to a certain value, at which point the capacity factors level off with further increases in monomer concentration. The electroosmotic flow velocity decreases with increasing monomer concentration. The efficiency for an unretained test probe (acetone) reaches 270 000 plates/m.