Cds Structure for the Normal Conducting Accelerating Cavities in Tesla Linear Collider
نویسندگان
چکیده
Due to some beam dynamic requirement, accelerating cavities for TESLA injector linacs should be embedded into solenoid magnetic field and TESLA superconducting cavities can not be applied. Consideration shows the Cut Disk Structure (CDS) as a good option for TESLA Normal Conducting (NC) accelerating cavities. The structure cells shape has been optimised at operating frequency 1300 MHz for different accelerating gradients and beam bore hole diameters. Results of the thermal stress analysis show the ability to operate with high accelerating gradient (up to 14 MV/m) and long ( 800 s) rf pulse. Different options for the structure segmentation, both single cavities and cavities with coupling bridges, are considered. Design parameters for CDS cavities are presented.
منابع مشابه
The Wakefields and Loss Factors in Superconducting Accelerating Cavities for Tesla Collider
The first stage of TTF superconducting electron linac is a in its final state of assembling. Many of superconducting accelerating cavities attained already the planned for collider accelerating fields of 25 MV/m. However the problem of cost reduction of TESLA accelerating system is still actual. The propositions concerning modifications in accelerating cavities were signalled at several TESLA M...
متن کاملThe Wakefields in Superconducting Accelerating Cavities of New Type for TESLA Collider
The first stage of the TESLA Test Facility (TTF) superconducting electron linac is already in its final state of assembling. The large number of superconducting accelerating cavities underwent the various complicated preparation procedures and many of them reached the specified accelerating gradient of 25 MV/m. Nevertheless, as the RF accelerating system is dominating part of the future machine...
متن کاملImproved Surface Treatment of the Superconducting TESLA Cavities
The proposed linear electron-positron collider TESLA is based on 1.3 GHz superconducting niobium cavities for particle acceleration. For a center-of-mass energy of 500 GeV an accelerating field of 23.4 MV/m is required which is reliably achieved with a niobium surface preparation by chemical etching. An upgrade of the collider to 800 GeV requires an improved cavity preparation technique. In thi...
متن کاملEmittance-imposed Alignment and Frequency Tolerances for the Tesla Linear Collider
One option in building a future 500 GeV c.m. linear collider is to use superconducting 1.3 GHz 9-cell cavities. However, wakefields excited by the bunch train in the TESLA (TeV-Energy Super Conducting Linear Accelerator) collider can resonantly drive the beam into unstable operation such that a BBU (Beam Break Up) mode results or at the very least significant emittance dilution occurs. The larg...
متن کاملSuperconducting Superstructure for the TESLA Collider: New Results
A new cavity-chain layout has been proposed for the main linac of the TESLA linear collider [1]. This superstructurelayout is based upon four 7-cell superconducting standingwave cavities, coupled by short beam pipes. The main advantages of the superstructure are an increase in the active accelerating length in TESLA and a saving in rf components, especially power couplers, as compared to the pr...
متن کامل