Phase stability of Crn+1GaCn MAX phases from first principles and Cr2GaC thin-film synthesis using magnetron sputtering from elemental targets
نویسندگان
چکیده
Andrejs Petruhins, Arni Sigurdur Ingason, Martin Dahlqvist, Aurelija Mockuté, Muhammad Junaid, Jens Birch, Jun Lu, Lars Hultman, Per O A Persson and Johanna Rosén, Phase stability of Crn+1GaCn MAX phases from first principles and Cr2GaC thin-film synthesis using magnetron sputtering from elemental targets, 2013, Physica Status Solidi. Rapid Research Letters, (7), 11, 971-974. http://dx.doi.org/10.1002/pssr.201308025 Copyright: Wiley-VCH Verlag http://www.wiley-vch.de/publish/en/
منابع مشابه
Deposition of Al/Cu Multilayer By Double Targets Cylindrical DC Magnetron Sputtering System
A cylindrical direct current magnetron sputtering coater with two targets for deposition of multilayer thin films and cermet solar selective surfaces has been constructed. The substrate holder was able to rotate around the target for obtaining the uniform layer and separated multilayer phases. The Al/ Cu multilayer film was deposited on the glass substrate at the following conditions: Working g...
متن کاملThe Effect of Substrate on Structural and Electrical Properties of Cu3N Thin Film by DC Reactive Magnetron Sputtering
The aim of this paper is to study the effect of substrate on the Cu3N thin films. At first Cu3N thin films are prepared using DC magnetron sputtering system. Then structural properties, surface roughness, and electrical resistance are studied using X-ray diffraction (XRD), the atomic force microscope (AFM) and four-point probe techniques respectively. Finally, the results are investigated and c...
متن کاملMechanical Properties and Microstructural Evolution of Ta/TaNx Double Layer Thin Films Deposited by Magnetron Sputtering
Crystalline tantalum thin films of about 500nm thickness were deposited on AISI 316L stainless steel substrate using magnetron sputtering. To investigate the nano-mechanical properties of tantalum films, deposition was performed at two temperatures (25°C and 200°C) on TaNx intermediate layer with different N2/Ar flow rate ratio from 0 to 30%. Nano-indentation was performed to obtain the mechani...
متن کاملTheoretical stability, thin film synthesis and transport properties of the Mon+1GaCn MAX phase
Rahele Meshkian, Arni Sigurdur Ingason, Martin Dahlqvist, Andrejs Petruhins, Unnar B. Arnalds, Fridrik Magnus, Jun Lu and Johanna Rosén, Theoretical stability, thin film synthesis and transport properties of the Mon+1GaCn MAX phase, 2015, Physica Status Solidi. Rapid Research Letters, (9), 3, 197-201. http://dx.doi.org/10.1002/pssr.201409543 Copyright: Wiley-VCH Verlag http://www.wiley-vch.de/p...
متن کاملInfluence of aging temperature on phase transformation and mechanical behavior of NiTi thin films deposited by magnetron sputtering technique
In this study, NiTi thin films were deposited on the glass and NaCl substrates by means of magnetron sputtering method. The influence of aging temperature, over the range 300-500 oC, on phase transformation and mechanical properties of the sputtered NiTi thin films were studied by differential scanning calorimetry (DSC) and nano-indentation assay, respectively. The DSC curves showed that the ag...
متن کامل