Automatic Control Point Measurement

نویسنده

  • EBERHARD GÜLCH
چکیده

The measurement of ground control points is an important task for the absolute orientation of stereo models, for digital aerial triangulation or for the registration of satellite imagery. In the Digital Photogrammetric Systems existing today this task is usually completely performed by a human operator. There exist, however, methods, that can identify and/or localize control points or control structures in an automated, but very seldom in an autonomous way. A short evaluation of the performance of some representative methods is given. The measurement of signalized ground control by image matching and by feature extraction tools has shown similar quality than the manual measurement of such points in digital aerial or satellite imagery.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Automatic Control Point Measurement

Nowadays the tenor of reports on applications of digital photogrammetric procedures consists of a unison message: processing modules of automatic image orientation are available in digital photogrammetric systems and with them the productivity is much higher than with all existing conventional photogrammetric plotters. In fact, interior and relative orientation procedures as well as automated a...

متن کامل

Hybrid Measurement Scenarios in Automated Close-range Photogrammetry

Automated close-range photogrammetric measurement has traditionally been associated with expensive specialist cameras and usually requires highly controlled image illumination conditions. In the past few years, however, there has been a significant amount of research into the development of automated routines and algorithms that support the employment of consumer-grade colour digital cameras fo...

متن کامل

Experimental values for adjusting an automatic control valve in gas pipeline transportation

When a natural gas pipeline ruptures, the adjacent automatic line control valves (ALCVs) should close quickly to prevent leakage or explosion. The differential pressure set point (DPS) at each valve location is the main criteria for value setting in ALCV action. If the DPS is not properly adjusted, the ALCV may mistakenly close or it may not take any action at proper time. This study focused on...

متن کامل

Automatic Photo Orientation via Matching with Control Patches

Traditional aerial-triangulation has long relied on control points orientating the photo models into a ground-based coordinate system, reducing the distortion effect when tying photos by imperfect photo measurements, and calibrating camera inner parameters. Field surveying preparing for adequate number of control points and manual measurements of the control points afterwards on the photos cost...

متن کامل

Realization of Automatic Measurement and Bionic Control of Rotary Heart Pumps

AbstractThe comfortability of the receiptor with a left ventricular assist pump becomes more and more important along with the daily prolonged survival. Thereby it is necessary to achieve automatic measurement and bionic control for heart pump. The key-point is to improve the sensitivity of flow rate change after the pressure head variation in the pump, so as to maintain the flow rate balance b...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2001