A Wide-band Low-Noise Transimpedance Preamp
نویسنده
چکیده
A transimpedance ampli er with nominal performance of 355MHz bandwidth, 20.6k transresistance, total equivalent input current noise of 43.1nA rms, and power dissipation of 20.7mW is presented.
منابع مشابه
Analyzing the Effect Adding an Active Feedback Network with an Inductive behavior to a Common-Gate Topology as a Transimpedance Amplifier for Low-Power and Wide-Band Communication Applications
Common Gate (CG) topologies are commonly used as the first stage in Transimpedance Amplifiers (TIA), due to their low input resistance. But, this structure is not solely used as a TIA and comes with other topologies such as differential amplifiers or negative resistances and capacitances. This paper deals with analyzing the effect of adding an active feedback network to a common gate topology...
متن کاملA 4.7μW Switched-Bias MEMS Microphone Preamplifier for Ultra-Low-Power Voice Interfaces
Abstract This paper presents a switched-bias MEMS microphone preamplifier for an ultra-low-power voice interface. A switched-MOSFET periodically changes the MOSFET between strong inversion and accumulation to inherently reduce 1/f noise. In addition, a proposed coupling capacitor allows the microphone to benefit from a high bias voltage while the preamp can use a low VDD. The preamp achieves 7 ...
متن کاملDesign of CMOS Broadband Transimpedance Amplifier with Cross Coupled Current Conveyor and series inductive Peaking
This paper hearsay a unique cross-coupled current conveyor based cmos transimpedance amplifier with series inductive peaking design to achieve an input capacitive load insensitive, low noise and augment the bandwidth of transimpedance amplifier. The peaking inductor is in series with the capacitor constituting a dominant pole. It boosts the band width of the amplifier.The whole transimpedance a...
متن کاملA Current Re-use Quadrature Front End Receiver for Ism Band
This paper presents a current re-use quadrature front end receiver architecture for ISM Band. The proposed architecture is a stacked QLMV cell which consists of a low-noise amplifier (LNA), mixer and voltage-controlled oscillator (VCO), which feeds into the intermediate frequency (IF) load. The LNA is a common source amplifier with Ls source degeneration, a double-balanced Gilbert cell mixer an...
متن کاملTransimpedance Amplifier (TIA) Design for 400 Gb/s Optical Fiber Communications
(ABSTRACT) Analogcircuit/IC design for high speed optical fiber communication is a fairly new research area in Dr. Ha's group. In the first project sponsored by ETRI (Electronics and Telecommunication Research Institute) we started to design the building blocks of receiver for next generation 400 Gb/s optical fiber communication. In this thesis research a transceiver architecture based on 4x100...
متن کامل