Geotechnical in situ characterization of subaquatic slopes: The role of pore pressure transients versus frictional strength in landslide initiation
نویسندگان
چکیده
[1] Mineralogical composition and pore fluid pressure are the crucial controls for mechanical stability of watersaturated sediments. Their in situ measurements were undertaken in earthquake-triggered slope deposits in Lake Lucerne (Switzerland) in addition to geophysical characterization and laboratory index properties, shear and consolidation experiments on core. Two lithological units were identified: A weak, lightly underconsolidated section of postglacial silty clays overlies overconsolidated finegrained glacial deposits with coarser components and excess fluid pressure (ca. 2.5 higher than in the hanging wall clay). In the event of an earthquake, hydrofracturing in the overconsolidated section facilitates an upward pore pressure pulse to the base of the softer, less stable unit. Here, excess pore pressure initiates sliding along a failure plane at the lithological boundary, causing the entire postglacial sedimentary section to slip downslope. We propose that many submarine landslides at active and passive continental margins may follow this mechanism of pore pressure-induced failure. Citation: Stegmann, S., M. Strasser, F. Anselmetti, and A. Kopf (2007), Geotechnical in situ characterization of subaquatic slopes: The role of pore pressure transients versus frictional strength in landslide initiation, Geophys. Res. Lett., 34, L07607, doi:10.1029/2006GL029122.
منابع مشابه
Strength-Flow Parameters of Loose Silty Sands From Piezocone Tests
Piezocone penetration tests with dissipation phases are particularly useful for geotechnical site characterization. They also provide three independent readings with depth from a single sounding as well as time-rate information. In past investigations, only silty sands with specific silt content have been tested and complete sets of tests have not been conducted to evaluate the influence of dif...
متن کاملNucleation of slip-weakening rupture instability in landslides by localized increase of pore pressure
We model landslide initiation as slip surface growth driven by local elevated pore pressure, with particular reference to submarine slides. Assuming an elastic medium and friction that weakens with slip, solutions exist in which the slip surface may dynamically grow, without further pore pressure increases, at a rate of the order of the sediment shear wave speed, a situation comparable to earth...
متن کاملAssessment of the Drain Conditions on Variations of the Pore Pressure in Surrounding Soil of the Tunnel
Excess pore pressure under seismic loadings has always been a main concern in geotechnical engineering practices. The phenomenon in soil can cause an effective stress and hence cause the shear strength of the soil to decrease considerably and large deformations to occur in the area. Generally, increases in pore pressure occur in un-drained conditions. If it is formed, its consequences decrease ...
متن کاملACTIVE EARTH PRESSURE IN COHESIVE-FRICTIONAL SOILS USING FEM AND OPTIMIZATION
Calculation of lateral earth pressure on retaining walls is one of the main issues in geotechnics. The upper and lower bound theorems of plasticity are used to analyze the stability of geotechnical structures include bearing capacity of foundations, lateral earth pressure on retaining walls and factor of safety of slopes. In this paper formulation of finite element limit analysis is introduced ...
متن کاملMathematical modelling of the landslide occurred at Gagliano Castelferrato (Italy)
Shallow slopes in clayey colluvial covers are often involved in progressive downhill motion with discontinuous rate of movements, depending on fluctuations in pore-water pressure. In geotechnical engineering research on natural slopes, the main efforts have been concentrated on stability analysis, always with a rigid perfectly plastic body assumption. In case of slow slope movements, however, t...
متن کامل