A revisit to some wheel–workpiece interaction problems in surface grinding
نویسندگان
چکیده
This paper revisited some wheel–workpiece interaction problems in surface grinding including the profile of heat flux and the variation of the wheel’s elastic modulus. A method of using an optical microscope and a CCD camera was applied to capture the depth and width of the heated zone, the details of the temperature field and the stability of the heat flux. It was found that the heat flux in up-grinding can be modeled as a triangle with its apex at the inlet of the wheel–workpiece contact arc. The elastic modulus of the grinding wheel decreases significantly when the grinding temperature is beyond a critical value and can be described by a power law. It was also found that the depth of cut has almost no effect on the partition of the grinding energy. 2002 Elsevier Science Ltd. All rights reserved.
منابع مشابه
Study on Experimental and Modeling of Rotary Roll Dressing of Grinding Wheels
Two of the important parameters in grinding operation are surface roughness of the workpiece and the amount of consumed energy. These parameters are strongly affected by the condition of grinding wheel surface which is dependent on the dressing parameters. Predicting the roughness of the grinding wheel surface after dressing with known dressing parameters can improve the grinding process. Resea...
متن کاملSystems Approach to Off-Round Grinding
Off-round grinding performed on CNC cylindrical grinding is a relatively new process. This paper takes a systems approach and discusses the various inputs and outputs and highlights the potential problems that production engineers face in implementing this new process. The effect of the inputs to the off-round grinding process such as the grinding machine, wheel, grinding fluid and the workpiec...
متن کاملFundamental Study on Cross Axis Grinding Method
In this study, it is experimentally investigated that the surface generation process in the cross axis grinding method with small diameter grinding wheel. In this grinding method, workpiece surface speed and sum of both wheel working surface speed and wheel feed rate crossed each other. Therefore, it is the largest characteristic that the cross angle, which is defined as the angle between the w...
متن کاملModeling and simulation of grinding processes based on a virtual wheel model and microscopic interaction analysis
Grinding is a complex material removal process with a large number of parameters influencing each other. In the process, the grinding wheel surface contacts the workpiece at high speed and under high pressure. The complexity of the process lies in the multiple microscopic interaction modes in the wheel-workpiece contact zone, including cutting, plowing, sliding, chip/workpiece friction, chip/bo...
متن کاملSurface hardness improvement in high efficiency deep grinding process by optimization of operating parameters
The grinding is one of the most important methods that directly affects tolerances in dimensions, quality and finished surface of products. One of the major problems in the material removal processes specially grinding is the heat generation during the process and the residual tensile stress in the surfaces of product. Therefore, optimization of High Efficiency Deep Grinding (HEDG) process is t...
متن کامل