Necessary Conditions for Nonlinear Ultrasonic Modulation Generation Given a Localized Fatigue Crack in a Plate-Like Structure

نویسندگان

  • Hyung Jin Lim
  • Hoon Sohn
چکیده

It has been shown that nonlinear ultrasonics can be more sensitive to local incipient defects, such as a fatigue crack, than conventional linear ultrasonics. Therefore, there is an increasing interest in utilizing nonlinear ultrasonics for structural health monitoring and nondestructive testing applications. While the conditions, which are the necessary conditions that should be satisfied for the generation of nonlinear harmonic components, are extensively studied for distributed material nonlinearity, little work has been done to understand the necessary conditions at the presence of a localized nonlinear source such as a fatigue crack. In this paper, the necessary conditions of nonlinear ultrasonic modulation generation in a plate-like structure are formulated specifically for a localized nonlinear source. Then, the correctness of the formulated necessary conditions is experimentally verified using ultrasounds obtained from aluminum plates.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Fatigue Crack Growth Monitoring of an Aluminum Joint Structure

The detection, location, and sizing of a fatigue crack emanating from a fastener hole in an aluminum plate is investigated. Two linear arrays of surface mounted piezoelectric disk transducers send and receive ultrasonic guided waves that are transmitted, reflected, and scattered by both the joint geometry and the fatigue crack. A tomography algorithm is used to detect and locate the crack. Ampl...

متن کامل

Thermo-optical modulation of ultrasonic surface waves for NDE.

The well-known thermo-elastic effect of laser irradiation can be exploited to produce strong localized stresses when an expanded, long pulse, low-intensity laser beam is used to irradiate the specimen. These stresses will produce a parametric modulation of the received ultrasonic signals, that is somewhat similar to the acousto-elastic effect often used in nonlinear ultrasonic studies. It is sh...

متن کامل

In-situ ultrasonic monitoring of crack growth under static and dynamic loading conditions [5767-1]

Successful in-situ monitoring of crack initiation and growth is a necessary prerequisite for applying ultrasonic methods to structural health monitoring. For conventional ultrasonic testing methods, a focused beam may be used to directly image the crack tip; however, this method is difficult to apply during fatigue testing because of access limitations and couplant contamination issues. However...

متن کامل

Modeling of Corrosion-Fatigue Crack Growth Rate Based on Least Square Support Vector Machine Technique

Understanding crack growth behavior in engineering components subjected to cyclic fatigue loadings is necessary for design and maintenance purpose. Fatigue crack growth (FCG) rate strongly depends on the applied loading characteristics in a nonlinear manner, and when the mechanical loadings combine with environmental attacks, this dependency will be more complicated. Since, the experimental inv...

متن کامل

Detection of Small Horizontal Defects in Thin Isotropic Plates Using Ultrasonic Rayleigh-Lamb Waves

This paper considers the detection of symmetric crack-like defects in thin metallic plates using longitudinal ultrasonic waves. Only physically small defect sizes are considered in order that the initial stages of crack growth, for example during fatigue, can be detected. This method has the potential to be significantly faster for non-destructively detecting defects than conventional ultrasoni...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره 10  شماره 

صفحات  -

تاریخ انتشار 2017