Force and flow at the onset of drag in plowed granular media.

نویسندگان

  • Nick Gravish
  • Paul B Umbanhowar
  • Daniel I Goldman
چکیده

We study the transient drag force FD on a localized intruder in a granular medium composed of spherical glass particles. A flat plate is translated horizontally from rest through the granular medium to observe how FD varies as a function of the medium's initial volume fraction, ϕ. The force response of the granular material differs above and below the granular critical state, ϕc, the volume fraction which corresponds to the onset of grain dilatancy. For ϕ<ϕc FD increases monotonically with displacement and is independent of drag velocity for the range of velocities examined (<10 cm/s). For ϕ>ϕc, FD rapidly rises to a maximum and then decreases over further displacement. The maximum force for ϕ>ϕc increases with increasing drag velocity. In quasi-two-dimensional drag experiments, we use granular particle image velocimetry (PIV) to measure time resolved strain fields associated with the horizontal motion of a plate started from rest. PIV experiments show that the maxima in FD for ϕ>ϕc are associated with maxima in the spatially averaged shear strain field. For ϕ>ϕc the shear strain occurs in a narrow region in front of the plate, a shear band. For ϕ<ϕc the shear strain is not localized, the shear band fluctuates in space and time, and the average shear increases monotonically with displacement. Laser speckle measurements made at the granular surface ahead of the plate reveal that for ϕ<ϕc particles are in motion far from the intruder and shearing region. For ϕ>ϕc, surface particles move only during the formation of the shear band, coincident with the maxima in FD, after which the particles remain immobile until the sheared region reaches the measurement region.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

ar X iv : 1 00 8 . 41 18 v 2 [ co nd - m at . s of t ] 1 S ep 2 01 0 Force and flow transition in plowed granular media

We use plate drag to study the response of granular media to localized forcing as a function of volume fraction, φ. A bifurcation in the force and flow occurs at the onset of dilatancy, φc. Below φc rapid fluctuations in the drag force, FD, are observed. Above φc fluctuations in FD are periodic and increase with φ. Velocity field measurements indicate that the bifurcation in FD results from the...

متن کامل

Force and flow transition in plowed granular media.

We use plate drag to study the response of granular media to localized forcing as a function of volume fraction ϕ. A bifurcation in the force and flow occurs at the onset of dilatancy ϕc. Below ϕc rapid fluctuations in the drag force F(D) are observed. Above ϕc fluctuations in F(D) are periodic and increase in magnitude with ϕ. Velocity field measurements indicate that the bifurcation in F(D) r...

متن کامل

Influence of Afterbody and Boundary Layer on Cavitating Flow

The characteristics of a cavitation water tunnel test setup and the experiments of cavitation around different models are given in this paper. Models of test are formed from combination of head and variable length afterbody. The experiments are performed initially with the smooth head and then with the roughened head. Cavitation initiates both in the wake and after the head. If the nose of mode...

متن کامل

Slow Drag in a Granular Medium

We have studied the drag force acting on an object moving with low velocity through a granular medium. Although the drag force is a dynamic quantity, its behavior in this regime is dominated by the inhomogeneous distribution of stress in static granular media. We find experimentally that the drag force on a vertical cylinder is linearly dependent on the cylinder diameter, quadratically dependen...

متن کامل

Numerical Simulation of Air Flow around the NP Car Using the Realizable k-ε Turbulence Model to Predict Aerodynamic Forces and Moments

In this study, a numerical computational fluid dynamics study is conducted in order to predict the aerodynamic forces on the NP car. The turbulent air flow around the car is modeled using the realizable k-&epsilon; model. First, results are validated against those presented for the Ahmed&rsquo;s body. Next, the fluid flow around the car is simulated for different car speeds ( to mph) and fl...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Physical review. E, Statistical, nonlinear, and soft matter physics

دوره 89 4  شماره 

صفحات  -

تاریخ انتشار 2014