Thermal stability of DNA.

نویسندگان

R D Blake

S G Delcourt

چکیده

Tij and Delta Hij for stacking of pair i upon j in DNA have been obtained over the range 0.034-0.114 M Na+from high-resolution melting curves of well-behaved synthetic tandemly repeating inserts in recombinant pN/MCS plasmids. Results are consistent with neighbor-pair thermodynamic additivity, where the stability constant, sij , for different domains of length N depend quantitatively on the product of stability constants for each individual pair in domains, sijN . Unit transition enthalpies with average errors less than +/-5%, were determined by analysis of two-state equilibria associated with the melting of internal domains and verified from variations of Tij with [Na+]. Enthalpies increase with Tij , in close agreement with the empirical function: Delta Hij = 52.78@ Tij - 9489, and in parallel with a smaller increase in Delta Sij . Delta Hij and Delta Sij are in good agreement with the results of an extensive compilation of published Delta Hcal and Delta Scal for synthetic and natural DNAs. Neighbor-pair additivity was also observed for (dA@dT)-tracts at melting temperatures; no evidence could be detected of the familiar and unusual structural features that characterize tracts at lower temperatures. The energetic effects of loops were determined from the melting behavior of repeating inserts installed between (G+C)-rich barrier domains in the pN/MCS plasmids. A unique set of values for the cooperativity, loop exponent and stiffness parameters were found applicable to internal domains of all sizes and sequences. Statistical mechanical curves calculated with values of Tij([Na+]) , Delta Hij and these loop parameters are in good agreement with observation.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Improving Thermal Stability of Starch in Formate Fluids for Drilling High Temperature Shales

Starch is one of the most widely used biopolymers in water based drilling fluids to control fluid loss. The thermal stability of starch in common drilling fluids is low (93 °C). In this study, the thermal stability of starch has been evaluated in sodium/potassium formate and potassium chloride fluids. Samples of mud were prepared by formate salts (sodium and potassium) and potassium chloride wi...

متن کامل

Preparation of CuO/Water Nanofluids Using Polyvinylpyrolidone and a Survey on Its Stability and Thermal Conductivity

In this article CuO/water nanofluid was synthesized by using polyvinylpyrolidone (PVP) as the dispersant. Thenanofluid stability period and the heat transfer enhancement were determinedby measuring the thermal conductivities. To study the nano-fluid stability, zeta (ζ) potential, and absorbency were measured under different pH values and PVP surfactant concentrations; also thermal conductivity...

متن کامل

Performance, Thermal Stability and Optimum Design Analyses of Rectangular Fin with Temperature-Dependent Thermal Properties and Internal Heat Generation

In this study, we analysed the thermal performance, thermal stability and optimum design analyses of a longitudinal, rectangular fin with temperature-dependent, thermal properties and internal heat generation under multi-boiling heat transfer using Haar wavelet collocation method. The effects of the key and controlling parameters on the thermal performance of the fin are investigated. The therm...

متن کامل

Preparation of MWNT/TiO2 Nanoﬂuids and Study of its Thermal Conductivity and Stability

متن کامل