Cellular arrays during upward solidification of Pb - 30 wt % T 1 alloys
نویسنده
چکیده
2014 A quantitative study of the cellular or dendritic hexagonal arrays, obtained during upward solidification of Pb-30 wt% T1 alloys, is presented. These arrays are reconstituted by the Wigner-Seitz method which allows the determination of the primary spacing, the identification of the defects and the analysis of the disorganization of the interface structures by using concepts developed for two-dimensional melting. J. Phys. France 51 (1990) 625-637 1er AVRIL 1990, Classification Physics Abstracts 81.30F 68.70 61.70 47.90
منابع مشابه
Near-congruent solidification of castings
Chaput Kevin J. Ph.D., Purdue University, May 2015. Near-Congruent Solidification of Castings. Major Professor: Kevin Trumble. A study on the microstructure development of as-cast Cu-Mn alloys based around the congruent minimum at 34.6 wt % Mn and 873 oC was performed. Initially, this was to evaluate the alloy as an alternative to wide freezing range Pb and Sn bronzes that are plagued with poro...
متن کاملEXPERIMENTALl ANALYSIS OF PARTITION COEFFICIENT IN Al-Mg ALLOYS
Because the partition coefficient is one of the most important parameters affecting microsegregation, the aim of this research is to experimentally analyse the partition coefficient in Al-Mg alloys. In order to experimentally measure the partition coefficient, a series of quenching experiments during solidification were carried out. For this purpose binary Al-Mg alloys containing 6.7 and 10.2 w...
متن کاملModelling of dendritic growth in ternary alloy solidification with melt convection
A two-dimensional lattice Boltzmann-cellular automaton model is coupled with the CALPHAD (Calculation of Phase Diagrams) method for simulating dendritic growth during ternary alloy solidification with convection. In the model, the kinetics of dendritic growth is determined by the difference between the equilibrium liquidus temperature and the actual temperature at the solid/liquid interface, in...
متن کاملMODELLING OF THE PERMEABILITY FOR COLUMNAR DENDRITE STRUCTURES DURING SOLIDIFICATION OF MUSHY ALLOYS
A numerical model has been developed for the determination of liquid flow permeability through columnar dendrite during growth. The model is inclusive two stages, first numerical evolution of the dendrite shape during growth, and second numerical determination of the interdendritic liquid permeability. Simulation results shown which solute concentration by evolution of dendrite shape could resu...
متن کاملFormation of Cellular Structure on Metastable Solidification of Undercooled Eutectic CoSi-62 at. %
The relationship between emissivity, delay time, and surface growth for metastable solidification of CoSi-62 at. % eutectic alloys is reported from undercooling experiments conducted using electrostatic levitation. A fraction of the undercooled melt is first solidified to CoSi2 with subsequent nucleation in the mushy-zone of CoSi after an observed delay time. During this double recalescence eve...
متن کامل