Effect of Different Bonding Strategies on Adhesion to Deep and Superficial Permanent Dentin

OBJECTIVES To evaluate the effect of different bonding strategies on the microtensile bond strength to deep and superficial permanent dentin. METHODS Forty-eight teeth were randomly flattened according to the dentin depth: superficial dentin (SD) and deep dentin (DD). Subsequently, three adhesive systems were applied (n=8): an etch-and-rinse (Adper Single Bond 2 - SB), a "mild" two-step self-etching (Clearfil SE Bond - SE) and a one-step self-etching adhesive system (Futurabond - FB). Each specimen was restored with a composite resin and sectioned into 1.0-mm(2) thick slabs. After 24 hours, resin-dentin sticks were submitted to tensile stress in a universal testing machine (0.5 mm/min). Data were submitted to two-way ANOVA and Tukey's test at a level of 0.05%. RESULTS Superficial dentin showed the highest microtensile bond strength values, which differed statistically from those obtained in the deep dentin, irrespective of the adhesive system used. FB yielded the highest bond strength values, which were statistically similar to the bond strength values of SE, but statistically different from those obtained when the SB adhesive was used. CONCLUSIONS Bond strength obtained in superficial dentin was significantly higher than in deep dentin, for all adhesive systems tested. Adhesion was affected by the different bonding strategies: the one-step, low pH, acetone-based self-etching adhesive promoted the higher bond strength values, which were statistically similar to those obtained with the two-step, water-based self-etching adhesive.