UWFDM-1234 Neutronics Assessment of Molten Salt Breeding Blanket Design Options

DISCLAIMER This report was prepared as an account of work sponsored by an agency of the United States Government. Neither the United States Government, nor any agency thereof, nor any of their employees, makes any warranty, express or implied, or assumes any legal liability or responsibility for the accuracy, completeness, or usefulness of any information, apparatus, product, or process disclosed, or represents that its use would not infringe privately owned rights. Reference herein to any specific commercial product, process, or service by trade name, trademark, manufacturer, or otherwise, does not necessarily constitute or imply its endorsement, recommendation, or favoring by the United States Government or any agency thereof. The views and opinions of authors expressed herein do not necessarily state or reflect those of the United States Government or any agency thereof. Neutronics assessment has been performed for molten salt breeding blanket design options that can be utilized in fusion power plants. The concepts evaluated are a self-cooled Flinabe blanket with Be multiplier and dual-coolant blankets with He-cooled FW and structure. Three different molten salts were considered including the high melting point Flibe, a low melting point Flibe, and Flinabe. The same TBR can be achieved with a thinner self-cooled blanket compared to the dual-coolant blanket. A thicker Be zone is required in designs with Flinabe. The overall TBR will be ~1.07 based on 3-D calculations without breeding in the divertor region. Using Be yields higher blanket energy multiplication than obtainable with Pb. A modest amount of tritium is produced in the Be (~3 kg) over the blanket lifetime of ~3 FPY. Using He gas in the dual-coolant blanket results in about a factor of 2 lower blanket shielding effectiveness. We show that it is possible to ensure that the shield is a lifetime component, the vacuum vessel is reweldable, and the magnets are adequately shielded. We conclude that molten salt blankets can be designed for fusion power plants with neutronics requirements such as adequate tritium breeding and shielding being satisfied.