HPHT Diamond Crystallization in the Mg-Si-C System: Effect of Mg/Si Composition

نویسندگان

  • Yuri Palyanov
  • Igor Kupriyanov
  • Yuri Borzdov
  • Denis Nechaev
چکیده

Crystallization of diamond in the Mg-Si-C system has been studied at 7.5 GPa and 1800 ◦C with the Mg-Si compositions spanning the range from Mg-C to Si-C end-systems. It is found that as Si content of the system increases from 0 to 2 wt %, the degree of the graphite-to-diamond conversion increases from about 50 to 100% and remains at about this level up to 20 wt % Si. A further increase in Si content of the system leads to a decrease in the graphite-to-diamond conversion degree down to complete termination of diamond synthesis at Si content >50 wt %. Depending on the Si content crystallization of diamond, joint crystallization of diamond and silicon carbide and crystallization of silicon carbide only are found to take place. The cubic growth of diamond, typical of the Mg-C system, transforms to the cube-octahedron upon adding 1 wt % Si and then to the octahedron at a Si content of 2 wt % and higher. The crystallized diamonds are studied by a suite of optical spectroscopy techniques and the major characteristics of their defect-and-impurity structure are revealed. The correlations between the Si content of the Mg-Si-C system and the properties of the produced diamond crystals are established.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

EFFECT OF COMPOSITION ON PHASE EVOLUTION AND MICROSTRUCTURE OF REACTION BONDED MULLITE (RBM)

Compositions of Al2O3+Si, SiO2+Al and Al+Si systems were prepared to study the effect of reaction bonding process on the mullite formation. The composition of each system was adopted according to mullite stoichiometery and sintered in 700-1600°C range. Results showed that the formation of reaction bonded mullite starting from Al2O3+Si mixtures, proceeded in two partially overlapping steps, the ...

متن کامل

In Vitro behavior of mechanically activated nanosized Si-Mg-doped fluorapatite

Hydroxyapatite (HA) is perhaps the most attractive material for bone repair, replacement and regeneration, due to its chemical composition and crystallographic structure which are similar to those of natural bone mineral. However, replacement of various elements and compounds in HA, could improve biological properties of this material. The aim of this study was preparation, characterization and...

متن کامل

The effects of Na & Mg adsorption on the electrical properties of SiCNTs: A DFT study

In the present study we focused on the electronic and structural properties of Na and Mg adsorption on the surface of the (6, 6) armchair SiCNTs. The adsorption energy (Eads), band gap energy (Eg), partial density of state (PDOS), chemical potential (μ), global hardness (η), electrophilicity index (ω), global softness (S), work function values (φ) and work function change (Δφ) are calculated by...

متن کامل

Diamond Synthesis from Graphite in the Presence of Water and SiO2: Implications for Diamond Formation in Quartzites from Kazakhstan

Recent studies of microdiamonds from orogenic belts related to continental collisions induced experimentalists to explore new crystallization media possible for diamond synthesis. This has led to considerable progress in diamond-synthesis experiments under high pressures and high temperatures. Diamond was found to grow in a wide variety of systems, which drastically differ from the metal-solven...

متن کامل

The Effect of Artificial Aging Treatment and Lubrication Modes on the Cutting Force and the Chip Surface Morphology when Drilling Al-Si-Mg (A356) Cast Alloys

This article reports the effects of various artificial aging methods and lubrication modes (dry, mist, wet) on the recorded cutting forces and chip morphology in drilling Al-Si-Mg (A356) cast alloys. In the course of this work, the work part sampled were as-received alloy (T0), solution heat-treated alloy (SHT) and then aged alloys at 155°C, 180°C, and 220°C (T4, T6, T61, T7), respectively. The...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2017