RF Characteristics of BJT Dev or Fully Ion-Implant
نویسندگان
چکیده
A selectively ion-implanted collector (SIC) is implemented in a 0.8 um BiCMOS process to improve the RF characteristics of the BJT devices. The SIC BJT device has better ft and fmax than the FIC (fully ion-implanted collector) BJT device because the extrinsic base-collector capacitance is reduced by the SIC process. The fmax is 9.5GHz and ft is 7.8 GHz for the SIC BJT device while the fmax is 7.2 GHz and fmax is 4.5 GHz for the FIC BJT device when biased at Vce=3.6 V and Jc=0.09 mA/um2. The nois parameters are the same for both BJT devices but the associated gain is higher for the SIC BJT device.
منابع مشابه
Fully Differential Current Buffers Based on a Novel Common Mode Separation Technique
In this paper a novel common mode separation technique for implementing fully differential current buffers is introduced. Using the proposed method two high CMRR (Common Mode Rejection Ratio) and high PSRR (Power Supply Rejection Ratio) fully differential current buffers in BIPOLAR and CMOS technologies are implemented. Simulation results by HSPICE using 0.18μm TSMC process for CMOS based st...
متن کاملNovel H+-Ion Sensor Based on a Gated Lateral BJT Pair
An H⁺-ion sensor based on a gated lateral bipolar junction transistor (BJT) pair that can operate without the classical reference electrode is proposed. The device is a special type of ion-sensitive field-effect transistor (ISFET). Classical ISFETs have the advantage of miniaturization, but they are difficult to fabricate by a single fabrication process because of the bulky and brittle referen...
متن کاملINTEGRATED CIRCUIT DEVICE MISMATCH MODELING AND CHARACTERIZATION FOR ANALOG CIRCUIT DESIGN by
This work presents a new method for the modeling and characterization of resistor, MOSFET and bipolar transistor mismatch for analog circuit design. For transistors, sensitivities numerically calculated from SPICE models were used to infer mismatch variances in process parameters, such as sheet resistance and geometry variation, from electrical parameter mismatch variances, such as collector cu...
متن کاملProject on Mixed Signal Vlsi
This paper describes a doubly balanced Gilbert Cell mixer designed in BJT and CMOS technology to operate within 0 to 5 V. A 100 mv input signal was applied at both RF and LO port at different frequencies and their simulation curves were studied for a multiplier. The design done in BJT was taped out for fabrication and the chip on its return from foundry, was tested for its results. A comparison...
متن کاملComparison between Field Effect Transistors and Bipolar Junction Transistors as Transducers in Electrochemical Sensors
Field effect transistors (FET) have been widely used as transducers in electrochemical sensors for over 40 years. In this report, a FET transducer is compared with the recently proposed bipolar junction transistor (BJT) transducer. Measurements are performed on two chloride electrochemical sensors that are identical in all details except for the transducer device type. Comparative measurements ...
متن کامل