Fabrication and Testing of the First Module of the Sns Rfq
نویسندگان
چکیده
The 2.5 MeV injector for the Spallation Neutron Source is currently under construction at LBNL, which includes a 2.5 MeV high power, high duty factor four vane RFQ made of four modules. Transverse mode stabilization is obtained through a series of cross coupling rods. Each of the four RFQ modules is equipped with twenty fixed tuners, two active power and two vacuum ports. Fine frequency tuning is accomplished by adjusting the temperature differential in two separate cooling circuits, one on the RFQ body and the other near the vane tips. The RF drive is provided via 3-1/8 inch rigid coaxial lines and a coaxial RF vacuum barrier window. The first module has been built, confirming all fabrication, assembly and brazing techniques. This paper will cover the mechanical fabrication details as well as the early results from commissioning tests underway at LBNL.
منابع مشابه
The Fabrication and Initial Testing of the Sns Rfq
The Lawrence Berkeley National Laboratory (LBNL) is designing and building the 2.5 MeV front end injector for the Spallation Neutron Source (SNS) [1,2]. This injector comprises an H ion source, a low energy beam transport line (LEBT), a radio-frequency quadrupole (RFQ) and a beam transport line designed to provide fast chopping of the beam. The RFQ is designed to accelerate the H beam from the ...
متن کاملTechniques for Intense-Proton-Beam Profile Measurements
In a collaborative effort with industry and several national laboratories, the Accelerator Production of Tritium (APT) facility and the Spallation Neutron Source (SNS) linac are presently being designed and developed at Los Alamos National Laboratory (LANL). The APT facility is planned to accelerate a 100 mA H cw beam to 1.7 GeV and the SNS linac is planned to accelerate a 1 to 4 mA-average, H,...
متن کاملSynthesis and characterization of fiber reinforced polymer scaffolds based on natural fibers and polymer for bone tissue engineering application
A wide range of materials and scaffolding fabrication methods for bone tissue engineering have beenexplored recently. Fiber reinforced polymers (FRP) system appears to be a suitable system. By the exclusiveuse of biocompatible or bio-absorbable polymers and fibers, novel generation of scaffolds for applicationsin tissue engineering can be prepared. Mulberry Silk as highlighted...
متن کاملA 3.0MeV KOMAC/KTF RFQ Linac
The Radio-Frequency Quadrupole (RFQ) linac that will accelerate a 20mA proton beam from 50keV to 3MeV has been designed and is being fabricated as the first phase, KOMAC Test Facility (KTF), of the Korea Multipurpose Accelerator Complex (KOMAC) project at the Korea Atomic Energy Research Institute (KAERI). The physical, engineering designs and fabrication status of the RFQ are described.
متن کاملDesign and Fabrication of the KOMAC RFQ
A RFQ linac (3MeV, 350MHz, 20mA, CW and 324cm in length) is being built for the Korea Multipurpose Accelerator Complex (KOMAC). The physical and engineering design of the H/H RFQ linac are described. The fabrication process for the cold model and structure support is described. The current status of the RFQ is reported.
متن کامل