Two-step deposition of Al-doped ZnO on p-GaN to form ohmic contacts
نویسندگان
چکیده
Al-doped ZnO (AZO) thin films were deposited directly on p-GaN substrates by using a two-step deposition consisting of polymer assisted deposition (PAD) and atomic layer deposition (ALD) methods. Ohmic contacts of the AZO on p-GaN have been formed. The lowest sheet resistance of the two-step prepared AZO films reached to 145 Ω/sq, and the specific contact resistance reduced to 1.47 × 10-2 Ω·cm2. Transmittance of the AZO films remained above 80% in the visible region. The combination of PAD and ALD technique can be used to prepare p-type ohmic contacts for optoelectronics.
منابع مشابه
Investigation of post-annealing effect on efficient ohmic contact to ZnO thin film using Ti/Al metallization strategy
Ohmic and Schottky contacts are playing a major role in the field of ZnO based electronics device fabrication. It is seen that several works have been reported on metallization scheme, contacts with this semiconducting material. But, the thickness of semiconducting material and the choosing of substrate still remain imperfect and inefficient for advanced IC technology. To estimate contact resis...
متن کاملImproved Low Resistance Contacts of Ni/Au and Pd/Au to p-Type GaN Using a Cryogenic Treatment
A low resistance Ohmic contact to p-type GaN is essential for reliable operation of electronic and optoelectronic devices. Such contacts have been made using Ni/Au and Pd / Au contacts to p-type Mg-doped GaN (1.41x10 cm) grown by metalorganic chemical vapor deposition ( MOCVD ) on ( 0001 ) sapphire substrates. Thermal evaporation was used for the deposition of those metals followed by annealing...
متن کاملNovel Type of Ohmic Contacts to P-Doped GaN Using Polarization Fields in Thin InxGa-xN Capping Layers
The performance of devices fabricated from GaN and related compounds is strongly affected by the resistances caused by electrical contacts. To avoid excessive heating resulting in a failure of the device, specic contact resistances less than ,10 Wcm for light-emitting diodes (LEDs) and less than ,10 Wcm for laser diodes are required. This applies in particular to ohmic contacts on p-doped GaN ...
متن کاملCharacterization of Pd/Ni/Au ohmic contacts on p-GaN
A low-resistance ohmic contact to Mg-doped p-type GaN grown by metal-organic chemical vapor deposition (MOCVD) with a carrier concentration of 2 · 10 cm 3 using Pd/Ni/Au metallization was formed. An anneal at 500 C for 1 min in a flowing N2 ambient produced an excellent ohmic contact with a specific contact resistivity as low as 2.4 · 10 5 X cm. X-ray photoelectron spectroscopy (XPS) and Auger ...
متن کاملHighly low resistance and transparent NiÕZnO ohmic contacts to p-type GaN
We report on a promising Ni ~5 nm!/Al-doped ZnO ~AZO! ~450 nm! metallization scheme for low resistance and transparent ohmic contacts to p-GaN (5310 cm). It is shown that the as-deposited Ni/AZO contact shows a nonohmic characteristic due to the insulating nature of the as-deposited AZO. However, annealing the contacts at 450 and 550 °C for 2 min in air ambient results in linear current–voltage...
متن کامل