Effect of inertia on drop breakup under shear

نویسندگان

  • Yuriko Y. Renardy
  • Vittorio Cristini
چکیده

A spherical drop, placed in a second liquid of the same density and viscosity, is subjected to shear between parallel walls. The subsequent flow is investigated numerically with a volume-of-fluid continuous-surface-force algorithm. Inertially driven breakup is examined. The critical Reynolds numbers are examined for capillary numbers in the range where the drop does not break up in Stokes flow. It is found that the effect of inertia is to rotate the drop toward the vertical direction, with a mechanism analogous to aerodynamic lift, and the drop then experiences higher shear, which pulls the drop apart horizontally. The balance of inertial stress with capillary stress shows that the critical Reynolds number scales inversely proportional to the capillary number, and this is confirmed with full numerical simulations. Drops exhibit self-similar damped oscillations towards equilibrium analogous to a one-dimensional mass-spring system. The stationary drop configurations near critical conditions approach an inviscid limit, independent of the microphysical flowand fluid-parameters. © 2001 American Institute of Physics. @DOI: 10.1063/1.1331321#

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Effect of startup conditions on drop breakup under shear with inertia

A spherical drop is suspended in another liquid and sheared between parallel walls. Numerical simulations for drop deformation under simple shear typically begin with the drop placed in an established flow. For Stokes flow, the drop evolves in a monotone manner to a stationary state or to breakup. Experimental and numerical studies of this result in a critical curve which delineates the capilla...

متن کامل

Lattice Boltzmann Simulation of Deformation and Breakup of a Droplet under Gravity Force Using Interparticle Potential Model

Abstract In this paper interparticle potential model of the lattice Boltzmann method (LBM) is used to simulate deformation and breakup of a falling droplet under gravity force. First this model is applied to ensure that the surface tension effect is properly implemented in this model. Two tests have been considered. First, it has been checked an initial square drop in a 2D domain can freely def...

متن کامل

Drop Properties after Secondary Breakup

-Drop properties during and after secondary breakup in the bag, multimode and shear breakup regimes were observed for shock-wave-initiated disturbances in air at normal temperature and pressure. Test liquids included water, n-heptane, ethyl alcohol and glycerol mixtures to yield Weber numbers of 15--600, Ohnesorge numbers of 0.0025-0.039, liquid/gas density ratios of 579-985 and Reynolds number...

متن کامل

Compound jet instability in a microchannel for mononuclear compound drop formation

A mononuclear compound droplet generation system has been developed based on both the hydrodynamic flow focusing and the solvent exchange method. The results show that the current system provided excellent control over the jet diameters of individual fluid consisting of the compound jet and the resultant compound drop diameters. The compound droplets were controlled in the range of 46–90 μm. Th...

متن کامل

3D drop deformation and breakup in simple shear flow considering the effect of insoluble surfactant

We have developed a multi-phase SPH method to simulate arbitrary interfaces containing surface active agents (surfactants) that locally change the properties of the interface, such the surface tension coefficient [1]. Our method incorporates the effects of surface diffusion, transport of surfactant from/to the bulk phase to/from the interface and diffusion in the bulk phase. Neglecting transpor...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2000