ZnO nanosheet arrays constructed on weaved titanium wire for CdS-sensitized solar cells
نویسندگان
چکیده
Ordered ZnO nanosheet arrays were grown on weaved titanium wires by a low-temperature hydrothermal method. CdS nanoparticles were deposited onto the ZnO nanosheet arrays using the successive ionic layer adsorption and reaction method to make a photoanode. Nanoparticle-sensitized solar cells were assembled using these CdS/ZnO nanostructured photoanodes, and their photovoltaic performance was studied systematically. The best light-to-electricity conversion efficiency was obtained to be 2.17% under 100 mW/cm2 illumination, and a remarkable short-circuit photocurrent density of approximately 20.1 mA/cm2 was recorded, which could attribute to the relatively direct pathways for transportation of electrons provided by ZnO nanosheet arrays as well as the direct contact between ZnO and weaved titanium wires. These results indicate that CdS/ZnO nanostructures on weaved titanium wires would open a novel possibility for applications of low-cost solar cells.
منابع مشابه
Porous ZnO nanosheet arrays constructed on weaved metal wire for flexible dye-sensitized solar cells.
Porous zinc oxide (ZnO) nanosheet (NS) arrays constructed by connected nanocrystallites were built on weaved metal wire (WMW) via hydrothermal treatment followed by calcination, and used as photoanodes for flexible dye-sensitized solar cells (DSSCs). An overall light-to-electricity conversion efficiency (η) of 2.70% was achieved for the DSSC under 100 mW cm(-2) illumination, and this η was foun...
متن کاملCdS sensitized 3D hierarchical TiO2/ZnO heterostructure for efficient solar energy conversion
For conventional dye or quantum dot sensitized solar cells, which are fabricated using mesoporous films, the inefficient electron transport due to defects such as grain boundaries and surface traps is a major drawback. To simultaneously increase the carrier transport efficiency as well as the surface area, optimal-assembling of hierarchical nanostructures is an attractive approach. Here, a thre...
متن کاملSynthesis and Characterization of Graphene-ZnO Nanocomposite and its Application in Photovoltaic Cells
In this paper, we present a simple method for preparation of graphene-ZnO nanocomposites (G-ZnO). The method is based on thermal treatment of the graphene oxide (GO)/ZnO paste which reduces the graphene oxide into the graphene and leads to the formation of the G-ZnO nanocomposite. The structure, morphology and optical properties of synthesized nanocomposites are characterized with XRD, FESEM, F...
متن کاملHigh-efficiency cascade CdS/CdSe quantum dot-sensitized solar cells based on hierarchical tetrapod-like ZnO nanoparticles.
Quantum dot-sensitized solar cells (QDSCs) constructed using cascade CdS/CdSe sensitizers and the novel tetrapod-like ZnO nanoparticles have been fabricated. The cascade co-sensitized QDSCs manifested good electron transfer dynamics and overall power conversion efficiency, compared to single CdS- or CdSe-sensitized cells. The preliminary CdS layer is not only energetically favorable to electron...
متن کاملPreparation of CdIn2S4-CdS nanocomposite via a green route and using them in dot-sensitized solar cells for boosting efficiency
In this work In2S3 and CdS nanoparticles were prepared by a simple hydrothermal method and then annealed at 500 °C for 2 h in an Ar gas until CdIn2S4(CdIS)-CdS nanocomposites were formed. Afterwards, efficiency of the as-synthesized CdIS-CdS nanocomposite in quantum dot-sensitized solar cells (QDSSCs) was evaluated. For this purpose, the as-prepared CdIS-CdS nanocomposites were deposited on TiO...
متن کامل